Distributed I/O System ET 200S

New Information About the "ET 200S Distributed I/O System Manual"
3.4 2AI I 2/4WIRE High Feature Analog Electronic Module (6ES7134-4MB02-0AB0)
2AI I 2/4WIRE High Feature Technical Specifications (6ES7134-4MB02-0AB0)
Dimensions and weight
Dimensions W x H x D (mm)
15 x 81 x 52
(the total dimensions depend on the selected
terminal module)
Weight Approx. 45 g
Supports isochronous operation
Data for specific modules
* Yes
Supports I&M functions Yes
Number of inputs
Cable length
2
• Shielded Max. 200 m
Parameter length 12 bytes
Analog value representation S5 and S7 format
* Is supported if no interference frequency suppression or smoothing is configured.
Voltages, currents, potentials
Rated load voltage L+ (from the power module) 24 VDC
• Reverse polarity protection Yes
Power supply of the transmitters Yes
• Short-circuit protection Yes, 60 mA (for both channels)
Galvanic isolation
• Between the channels and backplane bus Yes
• Between the modules and load voltage L+ No at 2-wire
Yes at 4-wire
• Between the channels and PE Yes
• Between the channels No
• Permissible potential difference
• Between the channels 140 VDC/100 VAC (with isolated power supply
for the measuring transducer)
• Insulation tested 500 VDC
• Current consumption
• From the load voltage L+
(no sensor supply)
48 mA max.
• Power dissipation of the module Typically 1.2 W
Status, interrupts, diagnostics
Diagnostics functions
• Group error Red "SF" LED
• Diagnostics functions readable Yes
• Process interrupts * Configurable, violation of upper and lower limits
* Process interrupts are only sent if the process interrupt mechanism is not overloaded.
ET 200S
3-10 Product Information, 12/2006, A5E00743001-02