PV*SOL Expert 6.0 - Manual - Valentin Software

4. Allowing for Manufacturer Tolerances in Pre-Graded Sub-Arrays:
Losses (System)
o Enter the deviation of module output from power rating specified by the
manufacturer. This makes sense when you have pre-sorted the modules
according to power output.
o The resulting Module Output is displayed.
5. Direct Current Cabling to Inverter means the cable from the string distributor to the entry of
the inverter.
o Enter the single length of the direct current cables to the inverter.
o Select a String Cable Cross Section or enter a different cable cross
section in mm².
The sum of the cable cross sections of all strings is displayed.
Adopt entries for all arrays
-> Requirement:
More than one array is defined in the System > Technical data > PV generator dialog.
-> How to proceed:
The button "Use for all arrays" at the bottom of the Losses dialog.
Click on this button to copy all values entered in the active tab into all the other arrays.
103