PV*SOL Expert 6.0 - Manual - Valentin Software

14.2 Settings
Options > Settings
These settings stay put after closing a project.
Projects
• On the worksheet, Projects, you can specify with which project the programme
should open. You can select that either a new project or the last project worked on
appears each time the programme is started.
• “No monitoring of project components” gives you the option of selecting that
various Messages appear (click on field) or do not appear (leave field blank) during
programme use:
• Select a standard feed-in tariff for new projects. This should be an .eta-file. The
selected tarifr is displayed.
• Select either metric or imperial (U.K.) units.
see Project Design.
System Check
Here you can enter the settings that are required for the System Check.
Temperature and irradiation maximums are usually calculated from the Climate data file.
However, if you are certain about the maximum values that you wish to use as the basis for
system calculation, you can enter these as the set values.
Background Image
Define whether the current system or an uploaded image should be the program
background.
Load an image for grid connected systems and stand-alone systems, each.
Calculation Model
Select whether the Dynamic Temperature Model or the Linear Temperature Model is to be
used.
Please note that these setting remain in force after you exit the project.
Project report
Define your company's contact data for the project report.
Define Company Logo for Project Report Heading
Select a logo to appear in the header of the project report.
If you select “Show Company Logo on Screen”, the logo appears on PV*SOL’s main screen
as a background image.
199