The Type Lite User Guide - Freedom Scientific

Starting Starting the the Update
Update
You should now be ready to run the update on the
Type Lite.
1. Press F9 F9, F9
X to start the update.
2. A prompt warns that updating your unit may
destroy your files, and then asks if you are sure
you want to continue. Enter Y to proceed.
3. There is a second verification prompt. Press Y
again to proceed.
The Type Lite takes a few moments to verify the
program is valid. If speech was off, it is turned on. A
series of beeps indicates the process continues.
The Type Lite may prompt that it has detected "super
flash memory," and ask you to select bank A or B.
This indicates your Type Lite has two language banks.
Even if you have an English only version, both
language banks must be updated. Bank B must be
updated first, so select B the first time you run the
update. After successfully running the update, run it
again and select bank A.
When the validation process is finished, several
messages are displayed/spoken, warning you not to
do anything until the process is complete. The Type
Lite also indicates to turn off your unit when you
receive a continuous high pitch tone. Finally, it tells
you that if you hear rapid beeping for more than
thirty seconds, your update has failed.
90 Part # 440001-001 Rev. B