Manuale italiano-inglese Oberheim-Viscount MC3000 - Synth Zone
Manuale italiano-inglese Oberheim-Viscount MC3000 - Synth Zone
Manuale italiano-inglese Oberheim-Viscount MC3000 - Synth Zone
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
MC 3000<br />
Operating Manual<br />
The word DEFAULT appears below CC NR. In line with this, the value of that slider for<br />
the control assigned to it when the patch is recalled (i.e. the default value) appears<br />
below each slider. After locating on these values with the cursor keys, the user can turn<br />
the encoder or use the INC and DEC keys to modify them.<br />
Important note: when setting the default value of the volume, reverb and chorus, make<br />
sure that this operation has not already been carried out in the MESSAGES 1 page; To<br />
avoid the presence of contradictory data, it is advisable to set OFF status for all data<br />
which could be set in other pages.<br />
4.6.3 PEDALS<br />
The PEDALS page can only be accessed from the SLIDERS page of the CONTROLLERS<br />
section, by pressing the F6 function key.<br />
MC 3000 is able to support on its inputs both switch (i.e. sustain) and expression pedals<br />
(i.e. volume). Evidently a switch pedal will send only two MIDI messagges (0 when pedal<br />
is released and 127 when pedal is pressed) while an expression pedal will be able to send<br />
the entire data range (from 0 to 127)<br />
Please note that the instrument supports the following types of pedals:<br />
• Switch Pedals: Pedals with a NORMALLY CLOSED contact<br />
• Expression Pedals: Pedals equipped with a stereo jack connector. The input<br />
impedence must be included from 10 to 22 Kohm.<br />
N.B The use of unsuitable padals may causes damage to the machine's electronic<br />
components.<br />
<strong>Zone</strong><br />
Default<br />
Value<br />
CC assigned<br />
to pedals<br />
Here again, the top of the display contains the name of the current page, the name of the<br />
current patch and the lights indicating the activation status of its zones.<br />
The ZONE field appears below this; after locating here with the cursor keys, the user can<br />
turn the encoder or use the INC and DEC keys to select the zone where a specific type of<br />
control is to be assigned.<br />
The 8 pedals are shown in the centre of the display.<br />
Numerical values which identify the type of control assigned to the pedal corresponding, or<br />
OFF indicating that the pedal in question is not active in the current zone, appear below<br />
each pedal in line with CC NR. After locating on these values with the cursor keys, the<br />
user can turn the encoder or use the INC and DEC keys to select the type of control to be<br />
assigned to the corresponding pedal. The name of the control selected will appear<br />
automatically in the top of the screen, beside CC NAME, as a display message only.<br />
The word DEFAULT appears below CC NR.<br />
101