Manuale italiano-inglese Oberheim-Viscount MC3000 - Synth Zone

MC 3000
Operating Manual
8 ANNEX
8.1 RESET PROCEDURES (FACTORY SETTINGS)
The MC-3000 control software is extremely complex and its programming and optimization
have been very demanding tasks.
Every condition of use of the instrument has been analyzed, reproduced and verified, but
we are unable to rule out the possibility that particular situations may occur in which the
instrument is unable to operate correctly due to unpredictable external factors such as
magnetic fields or serious mains power disturbances.
For this reason, a number of special functions have been combined in a page which can
only be accessed using a special procedure, to be carried out when the instrument is
switched on.
To access the reset procedure, first switch the MC-3000 off and back on, keeping the
WRITE key pressed. The following video page will appear on the display:
As the presence of the SECTION field indicates, the MC-3000 allows the user to perform
a SELECTIVE RESET, meaning that the section and memory location to be initialized can
be decided.
The options available to the user in the section field are:
• ALL: The whole of the instrument's internal memory undergoes a RESET (factory
setting).
• PROGRAMS: Program reset.
• CHAIN: Reset of the data relating to the chains
• PG TABLES: Reset of the data relating to the program change tables.
• SYS TABLES: Reset of the data relating to the exclusive system tables
• DYNAMIC CURVES: Reset of the data relating to the dynamic curves
• AFTERTOUCH CURVES: Reset of the data relating to the Aftertouch curves.
Caution: when one or more sections undergo a RESET all the user data they contain
will be lost irremediably!
The range of the memory locations to be initialized within the chosen section can be
selected in the fields FROM and TO fields.
Once the desired settings have been made, press function key F6 (RUN) to start the
initialization procedure. When the procedure is complete the MC-3000 will repeat the
switch-on procedure.
141