Manuale italiano-inglese Oberheim-Viscount MC3000 - Synth Zone

MC 3000
Operating Manual
6.7 TOOLS
6.7.1 Introduction
The TOOLS section can be accessed from the UTILITY MASTER video page by pressing
function key F6 or using the cursor keys or turning the encoder to locate on option n 6 on
the screen, where the word TOOLS appears, and confirming with ENTER.
6.7.2 MOUSE SET-UP
This is the first page, which appears automatically when the section is accessed
The top of the display contains information about the operating mode, the page and the
current section. The bottom carries the usual icon rectangles indicating the pages in the
section, where the mouse icon is highlighted in reverse because it indicates the current
page.
In this page the user can set the mouse sensitivity by using the cursor keys to locate in the
MOUSE SENSIBILITY field and varying the number associated to it with the encoder or
the INC and DEC keys.
Moving one step lower using the down arrow cursor hey, the user can use the INC and
DEC keys or the encoder to set the MOUSE AUTOREPEAT function ON or OFF (With the
MOUSE REPEAT function active, when the central or right-hand key on the mouse is kept
pressed, the selected parameter is varied continuously).
6.7.3 BATTERY STATUS
This page can be accessed from any page of the TOOLS section by pressing the F2
function key corresponding to the BAT icon. This is a display page only, and so it is not
possible to select any options within it.
Battery N. 1
Battery N. 2
The top of the display contains information about the operating mode, the page and the
current section.
The central window clearly shows the charge level of the two lithium batteries inside the
instrument.
When just one line appears for each of the two batteries, and thus the level is close to the
EMPTY condition, it is essential to dump the data and replace the batteries.
134