SwitchBlade x3112 Installation Guide - Allied Telesis

More documents

Recommendations

Info

Chapter 2: Installation Installing the AT-SBx3112 Chassis The AT-SBx3112 Chassis is designed for rack mounted installation only. To install the AT-SBx3112 Chassis, perform the following procedures: “Preparing the Equipment Rack” on page 55 “Unpacking the AT-SBx3112 Chassis” on page 56 “Adjusting the Brackets” on page 57 “Installing the AT-SBx3112 Chassis in Equipment Rack” on page 60 “Installing the Chassis Ground Lug” on page 62 54
SwitchBlade x3112 Installation Guide Preparing the Equipment Rack To prepare for the installation of the SwitchBlade x3112 Switch into your equipment rack, perform the following procedure: Caution Due to its weight, the chassis should be mounted as low as possible in the equipment rack to maximize vertical stability. 1. Reserve 311.1 mm (12.25“) of vertical rack space for the installation of the AT-SBx3112 Chassis as shown in Figure 27. In addition, do not mount any other equipment within 152.4 mm (6”) above this space during installation. This additional vertical space is temporary and allows you enough room to lift and tilt the chassis into its position in the equipment rack without hitting other equipment - see Figure 31 on page 60. When the chassis is installed, this additional space is available for any other equipment that you may install. 463.5 mm (18.25”) 311.1 mm (12.25“) 152.4 mm (6”0) Figure 27. Reserving Vertical Rack Space 55
Page 1 and 2:
M/S PSU FAN MASTER SLAVE NORMAL FAU
Page 3 and 4: Electrical Safety and Emissions Sta
Page 5 and 6: Contents Preface ..................
Page 7 and 8: List of Figures Figure 1: Front Vie
Page 9 and 10: List of Tables Table 1. Safety Symb
Page 11 and 12: Preface This guide provides the har
Page 13 and 14: SwitchBlade x3112 Installation Guid
Page 15 and 16: Chapter 1 Overview This chapter pro
Page 17 and 18: POWER SwitchBlade x3112 Installatio
Page 45 and 46: 1808 SwitchBlade x3112 Installation
Page 49 and 50: Chapter 2 Installation This chapter
Page 53: SwitchBlade x3112 Installation Guid
Page 61 and 62: P O E 0 2 4 6 8 P O E S Y S T E M 1
Page 67 and 68: POWER SwitchBlade x3112 Installatio
Page 73 and 74: SBx31CFC SYS STATUS M/S PSU FAN M/S
Page 75 and 76: SYS STATUS M/S PSU FAN 10/100/1000B
Page 77 and 78: 0 1 22 23 SwitchBlade x3112 Install
Page 85 and 86: P O E 0 2 4 6 8 10 P O E SBx31FAN P
Page 91 and 92: POE PSU A and C PSU B and D PSU POW
Page 93 and 94: SYS STATUS 10/100/1000Base-T Switch
Page 95 and 96: Chapter 3 Troubleshooting This chap
Page 105 and 106:
Appendix A Technical Specifications
Page 107 and 108:
SwitchBlade x3112 Installation Guid
Page 109 and 110:
Page 111 and 112:
show all

SwitchBlade x3112 Installation Guide - Allied Telesis

Create successful ePaper yourself

Delete template?

Save as template?