SwitchBlade x3112 Installation Guide - Allied Telesis

SwitchBlade x3112 Installation Guide
Installing the AT-SBx3161 System Power Supply
The SwitchBlade x3112 can host up to four power supplies consisting of
two AT-SBx3161 System Power Supplies and two AT-SBx3165 PoE
Power Supplies. The AT-SBx3112 Chassis comes with three blank power
supply panels in chassis slots A, B, and C as displayed in Figure 39. Slot
D is left open for the installation of the first AT-SBx3161 System Power
Supply. Keep the blank power supply panels in place on the unused slots
to insure proper chassis airflow.
AT-SBx3165 PoE Power Supply Slots
A
B
AT-SBx3161 System Power Supply Slots
C
D
P
O
E
P
O
E
S
Y
S
T
E
M
S
Y
S
T
E
M
SB 31FAN
1891
Figure 39. Slots A to D for System and PoE Power Supplies
Note
The label for the AT-SBx3161 System Power Supply model number
is located on the right-hand side of the power supply handle as
shown in Figure 20 on page 41. This power supply may be installed
in one of the two power supply slots on the right-hand side of the
chassis - slots C or D. See Figure 39 for the location of these slots.
Warning
The AT-SBx3161 System Power Supply contains active electronic
devices, which can be damaged by electro-static discharges (ESD).
Follow the procedure given in “Protection Against Electrostatic
Discharge (ESD)” on page 64 to guard against ESD damage when
unpacking and installing these power supplies.
To install the AT-SBx3161 power supply, perform the following procedure:
1. Choose a slot in the chassis for the AT-SBx3161 System Power
Supply. You can install the system power supply in either of the two
right-hand slots - slot C or D. (See Figure 39 for the location of these
slots.) If this is the initial installation of the chassis, Allied Telesis
recommends slot D because it does not have a blank power supply
panel installed.
65