SwitchBlade x3112 Installation Guide - Allied Telesis
SwitchBlade x3112 Installation Guide - Allied Telesis
SwitchBlade x3112 Installation Guide - Allied Telesis
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Chapter 3<br />
Troubleshooting<br />
This chapter contains information about how to troubleshoot the<br />
<strong>SwitchBlade</strong> <strong>x3112</strong> in the event that a problem occurs.<br />
Note<br />
If after following the instructions in this chapter you are unable to<br />
resolve the problem, contact <strong>Allied</strong> <strong>Telesis</strong> Technical Support for<br />
further assistance. Refer to “Contacting <strong>Allied</strong> <strong>Telesis</strong>” on page 14<br />
for contact information.<br />
The following troubleshooting information is available:<br />
“AT-SBx31CFC Fabric Control Card PSU Fault LED Flashing Amber”<br />
on page 96<br />
“AT-SBx31CFC Fabric Control Card FAN Fault LED Flashing Amber”<br />
on page 97<br />
“AT-SBx31CFC Fabric Control Card SBx Status LEDs Flashing Amber”<br />
on page 98<br />
“AT-SBx31GP24 PoE Line Card Link LED is Off” on page 99<br />
“Power not Received on PoE Device” on page 100<br />
“AT-SBx31GS24 SFP Line Card Fiber Optic Port Link LED is Off” on<br />
page 101<br />
“AT-SBx31XZ4 XFP Line Card Port LED is Off” on page 102<br />
“Cannot Establish a Local (Out-of-Band) Management Session” on<br />
page 104<br />
95