SwitchBlade x3112 Installation Guide - Allied Telesis

More documents

Recommendations

Info

Chapter 2: Installation Installing the Chassis Ground Lug A terminal lug is provided with the AT-SBx3112 Chassis to provide a permanent connection to a good earth ground. This permanent connection is required to insure a common ground path is provided for all line cards and power supplies installed in the chassis. To install the # 10 AWG ground wire, perform the following procedure: 1. Prepare an adequate length of stranded grounding wire (10 AWG) for the ground connection. 2. Strip the grounding wire as shown in Figure 34. 11mm ±1mm 1.27 cm (0.44in. ±0.03in.) (0.5 in) 100 Figure 34. Stripping the Grounding Wire 3. Detach the ground lug that is attached to the chassis by removing the two screws on the rear of the chassis as displayed in Figure 35. 8 D SYSTEM PSU 10 1788 Figure 35. Removing Ground Lug Screws 4. Use a crimping tool to attach the wire to the grounding lug included with the chassis. 102 Figure 36. Attaching the Grounding Wire to the Grounding Lug 62
SwitchBlade x3112 Installation Guide 5. Install the ground lug as displayed in Figure 37. 8 D SYSTEM PSU 10 1789 Figure 37. Installing the Ground Lug and Wire 6. Connect opposite end of ground wire to the building protective earth. 63
Page 1 and 2:
M/S PSU FAN MASTER SLAVE NORMAL FAU
Page 3 and 4:
Electrical Safety and Emissions Sta
Page 5 and 6:
Contents Preface ..................
Page 7 and 8:
List of Figures Figure 1: Front Vie
Page 9 and 10:
List of Tables Table 1. Safety Symb
Page 11 and 12: Preface This guide provides the har
Page 13 and 14: SwitchBlade x3112 Installation Guid
Page 15 and 16: Chapter 1 Overview This chapter pro
Page 17 and 18: POWER SwitchBlade x3112 Installatio
Page 45 and 46: 1808 SwitchBlade x3112 Installation
Page 49 and 50: Chapter 2 Installation This chapter
Page 61: P O E 0 2 4 6 8 P O E S Y S T E M 1
Page 67 and 68: POWER SwitchBlade x3112 Installatio
Page 73 and 74: SBx31CFC SYS STATUS M/S PSU FAN M/S
Page 75 and 76: SYS STATUS M/S PSU FAN 10/100/1000B
Page 77 and 78: 0 1 22 23 SwitchBlade x3112 Install
Page 85 and 86: P O E 0 2 4 6 8 10 P O E SBx31FAN P
Page 91 and 92: POE PSU A and C PSU B and D PSU POW
Page 93 and 94: SYS STATUS 10/100/1000Base-T Switch
Page 95 and 96: Chapter 3 Troubleshooting This chap
Page 105 and 106: Appendix A Technical Specifications
show all

SwitchBlade x3112 Installation Guide - Allied Telesis

Create successful ePaper yourself

Delete template?

Save as template?