SwitchBlade x3112 Installation Guide - Allied Telesis

Chapter 2: Installation
3. Position the transceiver with the label facing up.
4. Slide the transceiver into the slot until it clicks into place as shown in
Figure 56.
1000 LINK
8 10
3 5 7 9 11
2031
Figure 56. Inserting the SFP Transceiver
5. Verify that the handle on the SFP transceiver is in the upright position,
as shown in Figure 57, to prevent inadvertently removing the
transceiver.
6. Remove the protective cover from the SFP transceiver, as shown in
Figure 57.
1000 LINK
8 10
3 5 7 9 11
2032
Figure 57. Removing the SFP Transceiver Protective Cover
7. Repeat this procedure to install other SFP transceivers
8. Go to “Cabling the Twisted-Pair or Fiber Optic Ports” on page 87 for
installation cabling guidelines in the SFP transceiver ports.
80