SwitchBlade x3112 Installation Guide - Allied Telesis
SwitchBlade x3112 Installation Guide - Allied Telesis
SwitchBlade x3112 Installation Guide - Allied Telesis
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Chapter 2: <strong>Installation</strong><br />
Installing the Chassis Blank Panels<br />
Ten blank panels are supplied with the AT-SB<strong>x3112</strong> Chassis. These<br />
panels must be installed in vacant slots to insure proper airflow throughout<br />
the chassis.<br />
To install the blank panels, perform the following procedure:<br />
1. Install a blank panel in each vacant slot from slots 0 to 11 where a line<br />
card or a AT-SBx31CFC Card has not been installed.<br />
2. Align the two thumb screws on the blank panel with the mounting<br />
holes on the front panel rails of the chassis.<br />
3. Finger tighten the two thumbscrews to attach the blank panel to the<br />
chassis.<br />
4. With a # 2 Phillips head screw driver, torque both thumbscrews to<br />
.56 Nm (5 lb-in) maximum.<br />
5. Repeat steps 2 through 4 for the remaining vacant slots.<br />
6. Store any unused blank panels in a secure place for future use.<br />
88