SwitchBlade x3112 Installation Guide - Allied Telesis
SwitchBlade x3112 Installation Guide - Allied Telesis
SwitchBlade x3112 Installation Guide - Allied Telesis
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Chapter 2: <strong>Installation</strong><br />
Protection Against Electrostatic Discharge (ESD)<br />
Proper ESD protection is required when handling the <strong>SwitchBlade</strong> <strong>x3112</strong><br />
line cards and power supplies. You need properly grounded using wrist or<br />
foot straps to eliminate the risk of ESD damage to the equipment.<br />
Caution<br />
Electrostatic Discharge (ESD) can damage components on the<br />
<strong>SwitchBlade</strong> <strong>x3112</strong> line cards and power supplies. Insure that<br />
proper ESD procedures are followed during installation.<br />
1. Verify that the chassis is electrically connected to earth ground.<br />
2. Wear an ESD-preventive device such as a foot strap or wrist strap,<br />
ensuring that it makes good contact with the user’s skin.<br />
If a foot strap is used, the floor must be ESD conductive.<br />
3. Connect the clip from the ESD-preventative device to the ESD socket<br />
on the lower right side of the AT-SB<strong>x3112</strong> Chassis front panel or an<br />
unpainted surface of the frame or rack as displayed in Figure 38. This<br />
ensures that unwanted ESD voltages safely flow to ground.<br />
7<br />
9<br />
11<br />
ESD<br />
1855<br />
Figure 38. ESD Socket<br />
64