SwitchBlade x3112 Installation Guide - Allied Telesis
SwitchBlade x3112 Installation Guide - Allied Telesis
SwitchBlade x3112 Installation Guide - Allied Telesis
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Chapter 2: <strong>Installation</strong><br />
Installing the XFP Transceivers<br />
To install an XFP transceiver in the AT-SBx31XZ4 Line Card, perform the<br />
following procedure:<br />
1. Remove the dust plug from a transceiver slot on the line card as<br />
shown in Figure 58.<br />
3<br />
SBx31XZ4<br />
0 1 2 3<br />
PORT ACTIVITY<br />
10G LINK / ACT<br />
5<br />
XFP XFP XFP XFP<br />
7<br />
Figure 58. Removing the XFP Slot Dust Cover<br />
2. Remove the transceiver from its shipping container.<br />
3. Position the transceiver with the label facing down.<br />
4. Slide the transceiver into the slot until it clicks into place, as shown in<br />
59.<br />
3<br />
SBx31XZ4<br />
0 1 2 3<br />
PORT ACTIVITY<br />
10G LINK / ACT<br />
5<br />
XFP XFP XFP XFP<br />
7<br />
1913<br />
Figure 59. Installing an XFP Transceiver<br />
5. Verify that the handle on the XFP transceiver is in the upright position,<br />
as shown in Figure 60, to prevent inadvertently removing the<br />
transceiver.<br />
82