Accusetter Manual - BC MacDonald & Co.

Selecting Time Delay for Auto Air Shutoff
1) With the column in RUN mode press the ENTER button.
2) Rotate the ENTER button until the display reads "SYSTEM" and then press the
ENTER button.
3) Rotate the ENTER button until the display reads "AUTO AIR" and then press the
ENTER button.
4) Rotate the ENTER button to select a "5 SEC", "10 SEC", or "15 SEC" second delay
before air shutoff and then press the ENTER button.
5) Press the "RUN" button to return to run mode.
Disabling Auto Air Shutoff
1) With the column in RUN mode press the ENTER button.
2) Rotate the ENTER button until the display reads "SYSTEM" and then press the
ENTER button.
3) Rotate the ENTER button until the display reads "AUTO AIR" and then press the
ENTER button.
4) Rotate the ENTER button to select "DISABLED" and then press the ENTER button.
5) Press the "RUN" button to return to run mode.
Operation
1) Place the air tooling in gage position in a part. The air flow will automatically
increase to the normal operating level.
2) Gage the part.
3) Remove the air tooling from the part. After the programmed time (5, 10, or 15
seconds) expires the air flow will be reduced to a minimal flow.
4-27