Accusetter Manual - BC MacDonald & Co.

PROGRAMMING - MULTIPLE FIXTURE MEASUREMENT
Select Limits
1) Rotate the ENTER button to display LIMITS.
2) Press the ENTER button.
MAX/MIN
1) "MAX" will display.
2) Press the ENTER button. "ON" or "OFF" will display.
3) Rotate the ENTER button to display ON and then press the ENTER button.
4) Rotate the ENTER button until the maximum size or deviation is displayed.
5) Position the upper mechanical pointer at that location on the bargraph display. To move
the pointer, loosen the thumbscrew.
6) Press the ENTER button. "MAX" will display.
7) Rotate the ENTER button to display "MIN".
8) Press the ENTER button. "ON" or "OFF" will display.
9) Rotate the ENTER button to display "ON" and then press the ENTER button.
10) Rotate the ENTER button until the minimum size or deviation is displayed.
11) Position the lower mechanical pointer at that location on the bargraph display.
12) Press the ENTER button.
13) "MIN" will display.
Approach (Optional)
1) Rotate the ENTER button to display "+APPRCH".
2) Press the ENTER button. "ON" or "OFF" will display.
3) Rotate the ENTER button to display your choice. (Select ON if using this limit
function. Select OFF if not using this limit function).
4) Press the ENTER button.
5) If ON, rotate the enter button until the +APPRCH size or deviation is displayed and
then press the ENTER button.. "+ APPRCH" will display.
6) Rotate the ENTER button to display "-APPRCH". Press the ENTER button "ON" or
"OFF" will display.
7) Rotate the ENTER button to display your choice. (Select ON if using this limit
function. Select OFF if not using this limit function). Press the enter button to select.
8) If ON, rotate the enter button to display the "-APPRCH" numerical value.
9) Press the ENTER button. "- APPRCH" will display.
3-36