Accusetter Manual - BC MacDonald & Co.

2.9 E9330 (1) Channel A/E Signal Conditioning Module
The E9330 module is a single channel air/electric amplifier which processes pneumatic
information from the air tooling and delivers a conditioned signal to the controller board
of the Accusetter II. The module is mounted in the lower bay of the Accusetter II.
The A/E module also contains a ZERO adjustment knob and a MAG adjustment knob for
initial input setup to accommodate the air tooling used..
The air tooling is connected to the air fitting on the front panel of the module. The
recommended length of air line from the module to the air tool is no more than six feet.
A minimum of 60 psi air must be supplied to the filter/regulator assembly on the rear of
the unit. The regulator is factory set to 44 psi.
A jumper strip labeled "A OUT" provides the option to select a pin, 1 -6, to output a high
level (+/-1.84VDC) signal to the I/O connectors.
Power to the column must be turned off prior to installing or removing a signal
conditioning module.
Refer to the Advanced Operation, A/E Module Setup section for additional
information on jumper settings and see Basic Operation, Setting A/E Mag & Zero
for additional information on setting Mag and Zero for a particular application.
Figure 2.9 - E9330 (1) Channel AE Signal Conditioning Module
2-13