Accusetter Manual - BC MacDonald & Co.
Accusetter Manual - BC MacDonald & Co.
Accusetter Manual - BC MacDonald & Co.
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
2.5 Rear Panel<br />
The <strong>Accusetter</strong> II rear panel contains the following items:<br />
Serial Number - The Edmunds Gages serial number is listed at the top of the rear panel.<br />
Fuse Locator - <strong>Co</strong>ntains a 10 Amp fuse.<br />
Power Switch - Use to switch the unit on or off.<br />
Power <strong>Co</strong>nnector - Plug the power cable (Edmunds #4550111) into the power connector<br />
and connect to input line voltage from 100 to 240 VAC at 50 or 60 Hz. The <strong>Accusetter</strong><br />
II contains a universal power supply that will automatically adjust to any line voltage in<br />
the above range.<br />
Power Outlet Jumper - In a multiple <strong>Accusetter</strong> II setup, plug power jumper cables<br />
(Edmunds #4550120) from the power outlet jumper on one unit to the power connector<br />
on the next unit.<br />
RS-232C <strong>Co</strong>nnector - Use to output gage results to an external data collector.<br />
IN/OUT A (25 Pin) - Use to input/output parallel and analog signals from another<br />
<strong>Accusetter</strong> II or to an external device using interface cable, Edmunds #4550203. See<br />
figure 2-3 for pin assignments.<br />
IN/OUT B (25 Pin) - Use to input/output parallel and analog signals from another<br />
<strong>Accusetter</strong> II or to an external device using interface cable, Edmunds #4550203. See<br />
figure 2-3 for pin assignments.<br />
44 PSI Inlet - When the air to electric module is installed in the lower bay, an air hose<br />
fitting will extend out the 44 psi inlet port on the rear of the <strong>Accusetter</strong> II. An air line is<br />
connected to this fitting and to the outlet side of the air filter/regulator assembly.<br />
2-6
Change language