Accusetter Manual - BC MacDonald & Co.

PROGRAMMING - MULTIPLE CHECK MEASUREMENT
Multiple Check Programming
Programming SETUP Options
1) With the column in RUN mode, Press the ENTER button and then rotate the ENTER
button until "SETUP" is displayed.
2) Press the ENTER button.
3) Rotate the ENTER button to select "XDUCER", "DEFINE" or "PART NAME" and
then press the ENTER button.
XDUCER Menu
Signal Conditioning
(Note: These parameters will be automatically set by module
recognition for E9310, E9320, E9330, or E9340 modules)
1) Rotate the ENTER button until SIG COND is displayed and then press
the ENTER button.
2) Rotate the ENTER button to select "AIR" or "ELEC" and then press the
ENTER button.
a) If "ELEC" was selected then rotate the ENTER button to select
"GAIN 1X" or "GAIN 10X" and then press the ENTER button to
return to the Xducer menu.
b) If "AIR" was selected then rotate the ENTER button to select LOW
MAG, MED MAG, or HIGH MAG and then press ENTER to return
to the Xducer menu.
Scale
1) Rotate the ENTER button until SCALE is displayed and then press the
ENTER button.
2) Rotate the ENTER button to select "INCH" or "METRIC".
3) Press the ENTER button and the Accusetter will return to the Xducer
menu and display "SCALE".
3-24