Accusetter Manual - BC MacDonald & Co.

PROGRAMMING - SYSTEM OPTIONS
SECURITY Menu
1) Rotate the enter button to display "SECURITY" and then press the ENTER
button.
2) "MAST" with a numerical value will display. Note: Master password must be
entered now to allow programming your own password. Contact Edmunds
Gages if master password is unknown.
3) Press the ENTER button after entering the master password.
4) "PASS" with a numerical value will display. Enter your password number.
Note: if no password is required, program 000.
5) Press the ENTER button to return to the system menu, "SECURITY" will
display.
How To Enter Numerical Values
Enter the correct numeral by pressing the enter button to move from one decimal
place to another. To change numbers rotate enter button left or right until desired
number is displayed.
AUTO RST Menu
If the gaging application uses a +PEAK, -PEAK, or TIR function the display will
normally stay latched on the peak reading until the RST button is pressed. The auto
reset option allows the operator to program a timer to automatically reset the
display without hitting the RST button. To program the auto reset feature from the
system menu:
1) Rotate the enter button to display "AUTO RST" and then press ENTER.
2) Rotate the enter button to select "ON" or "OFF" and then press the ENTER
button.
3) If OFF was selected then the Accusetter will return to the system menu and
display "AUTO RST". If ON was selected then "DELAY" with a numeric
value will be displayed.
4) Rotate the ENTER button to display your choice of 0 - 10 seconds time delay.
5) Press the ENTER button and ON will be displayed.
6) Press the RST button to return to the system menu and "AUTO RST" will be
displayed.
3-42