R308 AT Command Manual - wless.ru
R308 AT Command Manual - wless.ru
R308 AT Command Manual - wless.ru
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>R308</strong> <strong>AT</strong> <strong>Command</strong>s<br />
9 Upgrading from R2xx to <strong>R308</strong> on the ETRX2 Series<br />
<strong>R308</strong> firmware can be loaded on to an ETRX2 by bootloading through the serial port or by reflashing<br />
with an Ember Insight Adaptor. Cloning over the air is tricky because the new <strong>R308</strong> node<br />
and the old R2xx node will not join the same PAN. It is possible to clone by using an extra R2xx<br />
device, as shown in the step-by-step guide below.<br />
<strong>R308</strong><br />
S00=0004<br />
R2xx R2xx Start with 3 modules.<br />
Set the channel<br />
mask on the <strong>R308</strong><br />
source<br />
<strong>AT</strong>+EN<br />
R2xx<br />
R2xx<br />
Establish a PAN on<br />
any channel<br />
ZC<br />
ZR<br />
<strong>AT</strong>+CLONE<br />
R2xx<br />
R2xx<br />
Start to clone from a<br />
dummy device<br />
R2xx<br />
Unplug the target<br />
before the cloning is<br />
complete<br />
<strong>AT</strong>+EN<br />
<strong>R308</strong><br />
S00=0004<br />
R<br />
Bootload <strong>R308</strong> on to<br />
the source device, or<br />
replace it with the<br />
<strong>R308</strong> device.<br />
Establish a PAN.<br />
Plug in the target<br />
device<br />
<strong>AT</strong>+RECOVER<br />
<strong>R308</strong><br />
S00=0004<br />
channel 13<br />
R<br />
Start the recovery<br />
process<br />
<strong>R308</strong><br />
S00=0004<br />
channel 13<br />
<strong>R308</strong><br />
<br />
Figure 2. Cloning from an <strong>R308</strong> device<br />
©2012 Telegesis (UK) Ltd - 106 - <strong>AT</strong> <strong>Command</strong> <strong>Manual</strong> (Rev 3.08)
Change language