R308 AT Command Manual - wless.ru
R308 AT Command Manual - wless.ru
R308 AT Command Manual - wless.ru
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>R308</strong> <strong>AT</strong> <strong>Command</strong>s<br />
+SR – Set Source Route to Remote Device<br />
Execute <strong>Command</strong><br />
<strong>AT</strong>+SR:,,…<br />
Set the source route of a message sent to a<br />
remote device, starting with the NodeID of<br />
the remote device followed by all NodeIDs on<br />
the route from the remote node to the local<br />
node<br />
Use on<br />
All Devices<br />
Note: Setting up invalid routes may lead to<br />
listed devices becoming unavailable. To<br />
confirm a route use <strong>AT</strong>+FNDSR.<br />
Response<br />
OK<br />
or<br />
ERROR<br />
represents the error code explained in<br />
section 3.<br />
Stores route information for up to 30 hops which<br />
will be used when sending any message to a<br />
remote node, which is part of the listed devices.<br />
SW release R300 ●<br />
+FNDSR – Find the Source Route to a remote device<br />
Execute <strong>Command</strong><br />
Response<br />
<strong>AT</strong>+FNDSR:<br />
OK<br />
Where can be the remote node‟s<br />
EUI64 or address table index<br />
or<br />
ERROR<br />
Tries to find source route information to the<br />
specified device by sending a ZDO request<br />
to the remote device and thus triggering a<br />
reply.<br />
Use on<br />
Sink, COO<br />
Prompt<br />
SR:XX,,,…<br />
Where XX represents the number of hops to the<br />
remote node, EUI64 its EUI64 number followed by<br />
a list of NodeIDs starting with the remote node<br />
listing all nodes along the path to the local node<br />
represents the error code explained in<br />
section 3.<br />
SW release R302 ●<br />
©2012 Telegesis (UK) Ltd - 29 - <strong>AT</strong> <strong>Command</strong> <strong>Manual</strong> (Rev 3.08)
Change language