R308 AT Command Manual - wless.ru
R308 AT Command Manual - wless.ru
R308 AT Command Manual - wless.ru
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>R308</strong> <strong>AT</strong> <strong>Command</strong>s<br />
S11 – Device Specific<br />
Description<br />
Defines the behaviour of the Device.<br />
Parameters<br />
XXXX<br />
Operations<br />
R/W LOCAL<br />
R/W REMOTE<br />
Becomes effective<br />
Instantly<br />
Note<br />
On the ETRX2 series IRQ0,1,2,3 are<br />
generated by logic transitions on inputs<br />
I/O0,1,10,11 respectively, on the ETRX3<br />
series they are generated by logic level<br />
transitions on PA0, PA1, PB0 and PB6<br />
respectively<br />
Storage<br />
Non-Volatile<br />
Where XXXX represents a 16-bit hexadecimal<br />
number.<br />
Bit F (MSB): Set: I/O3 (ETRX2) or PB7 (ETRX3) is<br />
PWM as defined by S1B/S1D.<br />
Unset: Standard I/O pin.<br />
Bit E: Set: Enable Boost Mode<br />
Bit D: Set: Present 1.2V A/D-Reference at I/O0<br />
during measurement (ETRX2 only)<br />
Bit C: Set: I/O8 turns into A/D3, which can be read<br />
from S21 (ETRX2 only)<br />
Bit B: Set: Pad 38 turns into A/D4, which can be<br />
read from S22 (ETRX2 only)<br />
Bit A: Reserved<br />
Bit 9: Set: Enable wakeup on UART activity (1st<br />
input character is discarded)<br />
Bit 8: Set: Enable 100ms debouncing for all IRQs<br />
Bit 7: Set: IRQ3 on rising edge<br />
Bit 6: Set: IRQ3 on falling edge<br />
Bit 5: Set: IRQ2 on rising edge<br />
Bit 4: Set: IRQ2 on falling edge<br />
Bit 3: Set: IRQ1 on rising edge<br />
Bit 2: Set: IRQ1 on falling edge<br />
Bit 1: Set: IRQ0 on rising edge<br />
Bit 0: Set: IRQ0 on falling edge<br />
Factory Default<br />
0005<br />
SW release R301 ●<br />
©2012 Telegesis (UK) Ltd - 66 - <strong>AT</strong> <strong>Command</strong> <strong>Manual</strong> (Rev 3.08)
Change language