R308 AT Command Manual - wless.ru

More documents

Recommendations

Info

R308 AT Commands 9 Upgrading from R2xx to R308 on the ETRX2 Series R308 firmware can be loaded on to an ETRX2 by bootloading through the serial port or by reflashing with an Ember Insight Adaptor. Cloning over the air is tricky because the new R308 node and the old R2xx node will not join the same PAN. It is possible to clone by using an extra R2xx device, as shown in the step-by-step guide below. R308 S00=0004 R2xx R2xx Start with 3 modules. Set the channel mask on the R308 source AT+EN R2xx R2xx Establish a PAN on any channel ZC ZR AT+CLONE R2xx R2xx Start to clone from a dummy device R2xx Unplug the target before the cloning is complete AT+EN R308 S00=0004 R Bootload R308 on to the source device, or replace it with the R308 device. Establish a PAN. Plug in the target device AT+RECOVER R308 S00=0004 channel 13 R Start the recovery process R308 S00=0004 channel 13 R308 Figure 2. Cloning from an R308 device ©2012 Telegesis (UK) Ltd - 106 - AT Command Manual (Rev 3.08)
R308 AT Commands 10 Trademarks All trademarks, registered trademarks and products names are the sole property of their respective owners. 11 Disclaimer Product and Company names and logos referenced may either be trademarks or registered trademarks of their respective companies. We reserve the right to make modifications and/or improvements without prior notification. All information is correct at time of issue. Telegesis (UK) Ltd. does not convey any license under its patent rights or assume any responsibility for the use of the described product. 12 Contact Information Website: E-mail www.telegesis.com sales@telegesis.com Telegesis (UK) Limited Abbey Barn Business Centre Abbey Barn Lane High Wycombe Bucks HP10 9QQ UK Tel: +44 (0)1494 510199 Fax: +44 (0)5603 436999 13 References Telegesis – www.telegesis.com Ember – www.ember.com ©2012 Telegesis (UK) Ltd - 107 - AT Command Manual (Rev 3.08)
Page 1 and 2:
Telegesis TG-ETRXn-R308-AT-Commands
Page 3 and 4:
R308 AT Commands 1 Introduction Thi
Page 5 and 6:
R308 AT Commands of the module, the
Page 7 and 8:
R308 AT Commands 2.2 Prompt Overvie
Page 9 and 10:
R308 AT Commands 2.3.2 Non-ZigBee t
Page 11 and 12:
R308 AT Commands Command Overview (
Page 13 and 14:
R308 AT Commands +BLOAD - Enter The
Page 15 and 16:
R308 AT Commands S - S-Register Acc
Page 17 and 18:
R308 AT Commands SALL - Remote S-Re
Page 19 and 20:
R308 AT Commands +EN - Establish Pe
Page 21 and 22:
R308 AT Commands +DASSL - Disassoci
Page 23 and 24:
R308 AT Commands +RTABLE - Display
Page 25 and 26:
R308 AT Commands +NODEDESC - Reques
Page 27 and 28:
R308 AT Commands +SIMPLEDESC - Requ
Page 29 and 30:
R308 AT Commands +SR - Set Source R
Page 31 and 32:
R308 AT Commands +SN - Scan Network
Page 33 and 34:
R308 AT Commands +CCHANGE - Change
Page 35 and 36:
R308 AT Commands +BCAST - Transmit
Page 37 and 38:
R308 AT Commands +UCAST - Transmit
Page 39 and 40:
R308 AT Commands +SCAST - Transmit
Page 41 and 42:
R308 AT Commands +SSINK - Search Fo
Page 43 and 44:
R308 AT Commands +DMODE - Enter Dat
Page 45 and 46:
R308 AT Commands +RDATAB - Send Bin
Page 47 and 48:
R308 AT Commands +BSET - Set local
Page 49 and 50:
R308 AT Commands +BIND - Create Bin
Page 51 and 52:
R308 AT Commands 3 List of Error co
Page 53 and 54:
R308 AT Commands 4 S-Registers Most
Page 55 and 56: R308 AT Commands With a few excepti
Page 57 and 58: R308 AT Commands S02 - Preferred PA
Page 59 and 60: R308 AT Commands S07 - Parent’s 1
Page 61 and 62: R308 AT Commands 4.3 S-Registers fo
Page 63 and 64: R308 AT Commands S0D - Device Infor
Page 65 and 66: R308 AT Commands S10 - Extended Fun
Page 67 and 68: R308 AT Commands 4.4 I/O related S-
Page 69 and 70: R308 AT Commands S14 - ETRX2: Pull-
Page 71 and 72: R308 AT Commands S16 - Data Directi
Page 73 and 74: R308 AT Commands S1A - Input Buffer
Page 75 and 76: R308 AT Commands S1F - A/D1 Reading
Page 77 and 78: R308 AT Commands 4.5 S-Registers De
Page 79 and 80: R308 AT Commands S26 - Immediate Fu
Page 81 and 82: R308 AT Commands S29 -Timer/Counter
Page 83 and 84: R308 AT Commands S2D -Timer/Counter
Page 89 and 90: R308 AT Commands S39 - Power Mode D
Page 91 and 92: R308 AT Commands 4.6 Advanced Setti
Page 93 and 94: R308 AT Commands S42 - Cluster ID f
Page 95 and 96: R308 AT Commands S47 - Power Descri
Page 97 and 98: R308 AT Commands S4C - Endpoint 2 O
Page 99 and 100: R308 AT Commands 5 Build in Functio
Page 101 and 102: R308 AT Commands Overview of Action
Page 103 and 104: R308 AT Commands 7 ETRX357 Power Co
Page 105: R308 AT Commands 8.2 Interpreting R
show all

R308 AT Command Manual - wless.ru

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?