R308 AT Command Manual - wless.ru

R308 AT Commands
+IDREQ – Request Node’s NodeID
Execute Command
AT+IDREQ:[,XX]
Response
OK
(ZDO)
Where can be a node‟s EUI64, or
address table entry and XX is an optional
index number. In case an index number is
provided, an extended response is requested
asking the remote device to list its associated
devices (ie children).
Sends a broadcast to obtain the specified
Device‟s NodeID and optionally also
elements of its associated devices list.
or ERROR:
represents the error code explained in
section 3.
Prompt
AddrResp:[,,]
[nn. ]
Use on
All Devices
In case of an error an errorcode other than 00 will
be displayed and the prompt will end after the
errorcode.
Note
is the Remote node‟s EUI64 and
Providing FF as an address table entry is its NodeID. In case an extended
addresses the local node
response has been requested the requested
NodeIDs from the associated devices list are listed
as well.
SW release R302 ●
+EUIREQ – Request Node’s EUI64
Execute Command
AT+EUIREQ:< Address>,[,XX]
Where is the EUI64, NodeID or
address table entry of the node which is to
be interrogated about the node with the
NodeID specified in . XX is an
optional index number. In case an index
number is provided, an extended response is
requested asking the remote device to list its
associated devices (ie children).
Sends a unicast to obtain the specified
device‟s EUI64 and optionally also elements
of its associated devices list (extended
response).
Use on
All Devices
Note
Providing FF as an address table entry
addresses the local node
Response
SEQ:XX
OK
or ERROR:
(ZDO)
represents the error code explained in
section 3.
Prompt
AddrResp:[,,]
[dd. ]
In case of an error an errorcode other than 00 will
be displayed and the prompt will end after the
errorcode.
is the Remote node‟s EUI64 and
is its NodeID. In case an extended
response has been requested the requested
NodeIDs from the associated devices list are listed.
As with all unicasts after successful transmission
the sequence number of the unicast is stated using
the “SEQ:XX” prompt. When acknowledged (or
not) the accompanying “ACK:XX” (or “NACK:XX”)
prompt is displayed.
SW release R302 ●
©2012 Telegesis (UK) Ltd - 24 - AT Command Manual (Rev 3.08)