R308 AT Command Manual - wless.ru
R308 AT Command Manual - wless.ru
R308 AT Command Manual - wless.ru
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>R308</strong> <strong>AT</strong> <strong>Command</strong>s<br />
+DMODE – Enter Data Mode (Serial Link Mode)<br />
Execute <strong>Command</strong><br />
<strong>AT</strong>+DMODE:<br />
Where can be the remote node‟s<br />
EUI64, NodeID or address table index<br />
Use on<br />
All Devices<br />
Note<br />
Opening a serial link to end devices will<br />
result in a limited data rate which depends on<br />
the polling interval of the child.<br />
In Data mode all prompts are disabled<br />
Response<br />
SEQ:XX<br />
OK<br />
or<br />
ERROR<br />
Prompt<br />
ACK:XX<br />
or NACK:XX<br />
represents the error code explained in<br />
section 3 and XX is the sequence number of the<br />
unicast.<br />
Remote Prompt<br />
DataMODE:,<br />
OPEN<br />
Prompt<br />
DataMODE:,,<br />
[OPEN]<br />
Where is the NodeID of the<br />
remote node and is its EUI64.<br />
Where is the NodeID of the remote<br />
node and is its EUI64. Only if the<br />
errorcode equals 0 the data mode will open<br />
.<br />
SW release R302 ●<br />
+++ – Leave Data Mode<br />
Execute <strong>Command</strong><br />
+++<br />
Response<br />
CLOSED<br />
To leave data mode +++ must be entered at<br />
a minimum of 500ms after the last character<br />
which is to be transmitted to the remote<br />
node. In case the data payload contains +++<br />
it can be transmitted safely as long as it is<br />
made sure no more than 250ms pass<br />
between sending +++ and the previous<br />
character.<br />
Use on<br />
All Devices<br />
SW release R302 ●<br />
©2012 Telegesis (UK) Ltd - 43 - <strong>AT</strong> <strong>Command</strong> <strong>Manual</strong> (Rev 3.08)
Change language