R308 AT Command Manual - wless.ru

More documents

Recommendations

Info

R308 AT Commands S0F – Prompt Enable 2 Description Defines the behaviour of the Device. Operations R/W LOCAL R/W REMOTE Becomes effective Instantly Notes Use of bit 8 requires bit 1 to be unset Parameters XXXX Where XXXX represents a 16-bit hexadecimal number. Range 0000 to FFFF Bit F: Add prefix to local S-register reads (ETRX35n only) Bit E: Show RSSI and LQI for all received unicasts and broadcasts (ETRX35n only) Bit 9 – Bit D: Reserved Storage Non-Volatile Bit 8: Set: Show unhandled messages received by Endpoints 3 and above Bit 7: Set: Hide “AddrResp” prompt Bit 6: Set: Hide Network Manager Warning Bit 5: Set: Hide “DataMODE” prompt Bit 4: Set: Hide “CLOSED” prompt Bit 3: Set: Hide “OPEN” prompt Bit 2: Set: Hide all Sink Advertisements Unset: Show all Sink Advertisements, except advertisements by the current sink Bit 1: Set: Disable showing unhandled messages received by Endpoints 0, 2, 3 etc Bit 0: Set: Disable COO, FFD, SED and MED prompts Factory Default 0006 SW release R301 ● ©2012 Telegesis (UK) Ltd - 64 - AT Command Manual (Rev 3.08)
R308 AT Commands S10 – Extended Function Description Defines the behaviour of the Device. Operations R/W LOCAL R/W REMOTE Parameters XXXX Where XXXX represents a 16-bit hexadecimal number. Range 0000 to FFFF Becomes effective Instantly Notes Bit C: the ETRX357-LRS and ETRX357HR- LRS have an RF preamplifier, so the reported RSSI is 12dB higher than the power at the antenna Only set bit 8 if transmissions to the sink are infrequent! Storage Non-Volatile Bit F: Set: Don‟t exit data mode in case of data loss Bit E: Set: Don‟t accept Data Mode Bit D: Set: High RAM concentrator instead of Low RAM concentrator Bit C: Set: Display RSSI and LQI of the last hop when devices report to AT+SN or AT+ANNCE Bit B: Set: UCASTs and SCASTs wait for ACK Bit A: Set: Disable playing Tune when receiving AT+IDENT Bit 9: Set: Enable one second character timeout when entering data for xCASTB. Bit 8: Set: Actively search for a sink if none is known Bit 7: Set: Node doesn‟t replace existing sink with better one (lower cost) Bit 6: Set: Node doesn‟t lose sink if it couldn‟t be reached for three times Bit 5: Set: Sink won‟t reply to nodes searching for a sink Bit 4: Set: Node is Sink Bit 3: Set: Changes to S01 take effect instantly Bit 2: Set: Send BCAST[B] messages to routers only Bit 1: Set: Send unicast messages unacknowledged Bit 0: Set: Don‟t attach EUI64 to NWK frame when sending a message. Factory Default 0000 SW release R302 ● ©2012 Telegesis (UK) Ltd - 65 - AT Command Manual (Rev 3.08)
Page 1 and 2:
Telegesis TG-ETRXn-R308-AT-Commands
Page 3 and 4:
R308 AT Commands 1 Introduction Thi
Page 5 and 6:
R308 AT Commands of the module, the
Page 7 and 8:
R308 AT Commands 2.2 Prompt Overvie
Page 9 and 10:
R308 AT Commands 2.3.2 Non-ZigBee t
Page 11 and 12:
R308 AT Commands Command Overview (
Page 13 and 14: R308 AT Commands +BLOAD - Enter The
Page 15 and 16: R308 AT Commands S - S-Register Acc
Page 17 and 18: R308 AT Commands SALL - Remote S-Re
Page 19 and 20: R308 AT Commands +EN - Establish Pe
Page 21 and 22: R308 AT Commands +DASSL - Disassoci
Page 23 and 24: R308 AT Commands +RTABLE - Display
Page 25 and 26: R308 AT Commands +NODEDESC - Reques
Page 27 and 28: R308 AT Commands +SIMPLEDESC - Requ
Page 29 and 30: R308 AT Commands +SR - Set Source R
Page 31 and 32: R308 AT Commands +SN - Scan Network
Page 33 and 34: R308 AT Commands +CCHANGE - Change
Page 35 and 36: R308 AT Commands +BCAST - Transmit
Page 37 and 38: R308 AT Commands +UCAST - Transmit
Page 39 and 40: R308 AT Commands +SCAST - Transmit
Page 41 and 42: R308 AT Commands +SSINK - Search Fo
Page 43 and 44: R308 AT Commands +DMODE - Enter Dat
Page 45 and 46: R308 AT Commands +RDATAB - Send Bin
Page 47 and 48: R308 AT Commands +BSET - Set local
Page 49 and 50: R308 AT Commands +BIND - Create Bin
Page 51 and 52: R308 AT Commands 3 List of Error co
Page 53 and 54: R308 AT Commands 4 S-Registers Most
Page 55 and 56: R308 AT Commands With a few excepti
Page 57 and 58: R308 AT Commands S02 - Preferred PA
Page 59 and 60: R308 AT Commands S07 - Parent’s 1
Page 61 and 62: R308 AT Commands 4.3 S-Registers fo
Page 63: R308 AT Commands S0D - Device Infor
Page 67 and 68: R308 AT Commands 4.4 I/O related S-
Page 69 and 70: R308 AT Commands S14 - ETRX2: Pull-
Page 71 and 72: R308 AT Commands S16 - Data Directi
Page 73 and 74: R308 AT Commands S1A - Input Buffer
Page 75 and 76: R308 AT Commands S1F - A/D1 Reading
Page 77 and 78: R308 AT Commands 4.5 S-Registers De
Page 79 and 80: R308 AT Commands S26 - Immediate Fu
Page 81 and 82: R308 AT Commands S29 -Timer/Counter
Page 83 and 84: R308 AT Commands S2D -Timer/Counter
Page 89 and 90: R308 AT Commands S39 - Power Mode D
Page 91 and 92: R308 AT Commands 4.6 Advanced Setti
Page 93 and 94: R308 AT Commands S42 - Cluster ID f
Page 95 and 96: R308 AT Commands S47 - Power Descri
Page 97 and 98: R308 AT Commands S4C - Endpoint 2 O
Page 99 and 100: R308 AT Commands 5 Build in Functio
Page 101 and 102: R308 AT Commands Overview of Action
Page 103 and 104: R308 AT Commands 7 ETRX357 Power Co
Page 105 and 106: R308 AT Commands 8.2 Interpreting R
Page 107 and 108: R308 AT Commands 10 Trademarks All
show all

R308 AT Command Manual - wless.ru

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?