R308 AT Command Manual - wless.ru
R308 AT Command Manual - wless.ru
R308 AT Command Manual - wless.ru
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>R308</strong> <strong>AT</strong> <strong>Command</strong>s<br />
+BLOAD – Enter The Bootloader Menu<br />
Execute <strong>Command</strong><br />
<strong>AT</strong>+BLOAD<br />
Response<br />
<br />
The device leaves the <strong>AT</strong> command line and<br />
enters the bootloader menu for downloading new<br />
firmware.<br />
A description of the bootloading process can be<br />
found in the Development Kit Product <strong>Manual</strong>.<br />
Please note that the bootloader will <strong>ru</strong>n at a<br />
baudrate of 115k2, no parity, 8 data bits regardless<br />
of the current serial port settings.<br />
SW release R300 ●<br />
+CLONE – Clone Local Node To Remote Node (ETRX2 Series only)<br />
Execute <strong>Command</strong><br />
Response<br />
<strong>AT</strong>+CLONE:, Cloning…<br />
Use on:<br />
Source: FFD, COO<br />
Destination: All device types<br />
Notes<br />
The default password for R3xx nodes is<br />
“password”.<br />
A description of the cloning process can be<br />
found in the Development Kit Product<br />
<strong>Manual</strong>.<br />
Remote Response<br />
ENTERING BLOAD<br />
or<br />
ERROR<br />
Where represents the error code<br />
explained in section 3.<br />
This command clones the firmware of the local<br />
node to a remote node within the same PAN,<br />
whose address is given by .<br />
represents the remote node‟s<br />
8-character password. After completion a soft<br />
reset is caused on the remote end.<br />
SW release R304 ●<br />
©2012 Telegesis (UK) Ltd - 13 - <strong>AT</strong> <strong>Command</strong> <strong>Manual</strong> (Rev 3.08)
Change language