R308 AT Command Manual - wless.ru

More documents

Recommendations

Info

R308 AT Commands 2.9 Binding Management (ETRX3 Series only) +LBTABLE – Display Local Binding Table Read Command AT+LBTABLE Use on All Devices Response No. | Type | Active | LocalEP | ClusterID | Addr | RemEP 10. | Ucast | No | 01 | DEAD | 1234567887654321 | 01 11. | MTO | No | 01 | DEAD | E012345678876543 | 88 12. | Mcast | No | 01 | DEAD | CDAB 13. | Unused 14. | Unused 15. | Unused 16. | Unused 17. | Unused 18. | Unused 19. | Unused Entries in the local Binding Table. SW release R307 ● ©2012 Telegesis (UK) Ltd - 46 - AT Command Manual (Rev 3.08)
R308 AT Commands +BSET – Set local Binding Table Entry Write Command AT+BSET:,,, [,] Response OK Where is the type of binding as shown below, is the local endpoint is the cluster ID is either the EUI64 of the target device, or a multicast ID the remote endpoint which is not specified in case of a multicast binding. The new binding is created in the next available free binding table entry. Types: 1= Unicast Binding with EUI64 and remote EP specified 2= Many to one Binding with EUI64 and remote EP Specified 3= Multicast Binding with Multicast ID Specified Example AT+BSET:1,01,0002,000d6f000059474e,01 Note All parameters must have exactly the correct number of characters Use on All Devices SW release R307 ● +BCLR – Clear local Binding Table Entry Write Command AT+BCLR:XX Response OK Where XX is the entry number of the binding table entry which is to be cleared. To keep the numbering of the local binding table inline with the numbering of the remote binding table all remaining entries are moved to the beginning of the table. Use on or ERROR: represents the error code explained in section 3. All Devices SW release R307 ● ©2012 Telegesis (UK) Ltd - 47 - AT Command Manual (Rev 3.08)
Page 1 and 2: Telegesis TG-ETRXn-R308-AT-Commands
Page 3 and 4: R308 AT Commands 1 Introduction Thi
Page 5 and 6: R308 AT Commands of the module, the
Page 7 and 8: R308 AT Commands 2.2 Prompt Overvie
Page 9 and 10: R308 AT Commands 2.3.2 Non-ZigBee t
Page 11 and 12: R308 AT Commands Command Overview (
Page 13 and 14: R308 AT Commands +BLOAD - Enter The
Page 15 and 16: R308 AT Commands S - S-Register Acc
Page 17 and 18: R308 AT Commands SALL - Remote S-Re
Page 19 and 20: R308 AT Commands +EN - Establish Pe
Page 21 and 22: R308 AT Commands +DASSL - Disassoci
Page 23 and 24: R308 AT Commands +RTABLE - Display
Page 25 and 26: R308 AT Commands +NODEDESC - Reques
Page 27 and 28: R308 AT Commands +SIMPLEDESC - Requ
Page 29 and 30: R308 AT Commands +SR - Set Source R
Page 31 and 32: R308 AT Commands +SN - Scan Network
Page 33 and 34: R308 AT Commands +CCHANGE - Change
Page 35 and 36: R308 AT Commands +BCAST - Transmit
Page 37 and 38: R308 AT Commands +UCAST - Transmit
Page 39 and 40: R308 AT Commands +SCAST - Transmit
Page 41 and 42: R308 AT Commands +SSINK - Search Fo
Page 43 and 44: R308 AT Commands +DMODE - Enter Dat
Page 45: R308 AT Commands +RDATAB - Send Bin
Page 49 and 50: R308 AT Commands +BIND - Create Bin
Page 51 and 52: R308 AT Commands 3 List of Error co
Page 53 and 54: R308 AT Commands 4 S-Registers Most
Page 55 and 56: R308 AT Commands With a few excepti
Page 57 and 58: R308 AT Commands S02 - Preferred PA
Page 59 and 60: R308 AT Commands S07 - Parent’s 1
Page 61 and 62: R308 AT Commands 4.3 S-Registers fo
Page 63 and 64: R308 AT Commands S0D - Device Infor
Page 65 and 66: R308 AT Commands S10 - Extended Fun
Page 67 and 68: R308 AT Commands 4.4 I/O related S-
Page 69 and 70: R308 AT Commands S14 - ETRX2: Pull-
Page 71 and 72: R308 AT Commands S16 - Data Directi
Page 73 and 74: R308 AT Commands S1A - Input Buffer
Page 75 and 76: R308 AT Commands S1F - A/D1 Reading
Page 77 and 78: R308 AT Commands 4.5 S-Registers De
Page 79 and 80: R308 AT Commands S26 - Immediate Fu
Page 81 and 82: R308 AT Commands S29 -Timer/Counter
Page 83 and 84: R308 AT Commands S2D -Timer/Counter
Page 89 and 90: R308 AT Commands S39 - Power Mode D
Page 91 and 92: R308 AT Commands 4.6 Advanced Setti
Page 93 and 94: R308 AT Commands S42 - Cluster ID f
Page 95 and 96: R308 AT Commands S47 - Power Descri
Page 97 and 98:
R308 AT Commands S4C - Endpoint 2 O
Page 99 and 100:
R308 AT Commands 5 Build in Functio
Page 101 and 102:
R308 AT Commands Overview of Action
Page 103 and 104:
R308 AT Commands 7 ETRX357 Power Co
Page 105 and 106:
R308 AT Commands 8.2 Interpreting R
Page 107 and 108:
R308 AT Commands 10 Trademarks All
show all

R308 AT Command Manual - wless.ru

Create successful ePaper yourself

Delete template?

Save as template?