R308 AT Command Manual - wless.ru

R308 AT Commands
+CCHANGE – Change the network’s channel
Execute Command
AT+CCHANGE[:XX]
Ask all nodes in the network to change their
channel. If no channel is specified a random
channel out of the channels masked in S00
is picked which wasn‟t previously blacklisted
because of excessive packet loss (NM:ES
REPORT WARNING prompt)
Response
OK
or
ERROR
represents the error code explained in
section 3.
Use on
Network Manager
Parameters
Optional XX ranging from 0B to 1A
Note
The New channel needs to be masked in in
S00 for all nodes on the network. Ideally S00
should be identical for all nodes on a
network.
SW release R304 ●
2.8 Messaging
+ATABLE – Display Address Table
Read Command
AT+ATABLE
Use on
All Devices
Response
No. | Active | ID | EUI
00 | N | 0000 |000D6F0000012345
(…)
OK
Notes
Entry 05 contains the address of the node‟s
sink. The user can overwrite it to manually
select a different sink.
Entry 06 contains the address of the node
sending the most recently received
UCAST,SCAST or MCAST.
The address table is volatile and its contents
are lost if the device is powered down.
The Address Table contains nodes which can be
addressed by referring to the corresponding
address table entry. The “Active” column shows
nodes to which a message is currently in flight.
SW release R300 ●
©2012 Telegesis (UK) Ltd - 33 - AT Command Manual (Rev 3.08)