R308 AT Command Manual - wless.ru
R308 AT Command Manual - wless.ru
R308 AT Command Manual - wless.ru
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>R308</strong> <strong>AT</strong> <strong>Command</strong>s<br />
+SIMPLEDESC – Request Endpoint’s Simple Descriptor<br />
Execute <strong>Command</strong><br />
Response<br />
<strong>AT</strong>+SIMPLEDESC:,, SEQ:XX<br />
<br />
OK<br />
(ZDO)<br />
Where is the EUI64, NodeID or<br />
Address table entry of the node which is to be<br />
interrogated about the node with the NodeID<br />
specified in and XX is the number<br />
of the endpoint, which simple descriptor is to<br />
be read.<br />
Sends a unicast to obtain the specified<br />
device‟s active endpoint list.<br />
or ERROR:<br />
represents the error code explained in<br />
section 3.<br />
Prompt<br />
SimpleDesc:,<br />
EP:XX<br />
ProfileID:XXXX<br />
DeviceID:XXXXvXX<br />
InCluster:<br />
OutCluster:<br />
In case of an error an errorcode other than 00 will<br />
be displayed and the prompt will end after the<br />
errorcode<br />
is the Remote node‟s NodeID. In<br />
addition all active endpoints are listed as 8 bit<br />
hexadecimal numbers separated by commas.<br />
As with all unicasts after successful transmission<br />
Use on<br />
the sequence number of the unicast is stated using<br />
All Devices<br />
the “SEQ:XX” prompt. When acknowledged (or<br />
not) the accompanying “ACK:XX” (or “NACK:XX”)<br />
prompt is displayed.<br />
SW release R302 ●<br />
©2012 Telegesis (UK) Ltd - 27 - <strong>AT</strong> <strong>Command</strong> <strong>Manual</strong> (Rev 3.08)
Change language