OPERATIONS MANUAL

Simulator Handling
Mouse – How to Actuate a Circuit Breaker:
To pull or push a circuit breaker (CB), left-click
with the mouse on the respective CB. Pulled
CBs appear slightly larger, and have a longer
shadow. To help distinguish a pulled CB from a
pushed one, four orange triangles are attached
to the mouse cursor when hovering over a
pulled CB. For more details on CBs, refer to
chapter Electrical.
Mouse – How to Move the Yokes and Throttles:
When the mouse is placed
in the red zones—that is,
on the windshields, PFDs,
NDs, or seat areas—,
the yoke cursor appears,
allowing the mouse to
drag the aileron control
wheel left and right, and
the elevator stick forward
and aft (up and down).
When the mouse button
is released, all controls are
centered.
The yoke cursor also enables the mouse wheel to actuate the yoke stabilizer trim
switches. When in the red zones, avoid moving the mouse wheel while the autopilot is
engaged; stabilizer trimming may disengage the autopilot.
On the ground, when the groundspeed is above zero and below 40 kt, the yoke cursor
changes to a tiller cursor: drag and hold the cursor left or right to rotate the gear
steering tiller. Release the mouse button to center the tiller.
Within the green zone, the mouse is enabled to drag all four thrust levers
simultaneously—the mouse wheel may be used as well.
— Page 21 —
For preview only. Not for sale. Many pages are intentionally removed.