OPERATIONS MANUAL

Simulator Handling
Instructor > Network > Main:
• The main network is used to connect multiple Precision Simulators with each other; this will
synchronize the situational data and model data across all connected Precision Simulators.
The main network may also be used to connect third-party add-ons to the simulator.
• A multicomputer network requires the computers being connected through ethernet cables
(Wi-Fi is not recommended). If more than two computers are used, an ethernet switch is
required. Each client must be assigned to the respective server’s host address; the address
consists of certain numbers and can be checked and entered on Instructor > Preferences
> Basics. A network can also consist of multiple Precision Simulators running on a single
computer; in this case, the host address reads localhost.
• To start a network, go to one Precision Simulator, select The main server, and push the
Start button. Then, on each other Precision Simulator, select A main client and push the
associated Start button. There can be multiple clients, but only one server. Every client
connects to the same server. A third-party add-on acts like a Precision Simulator client.
— Page 70 —
For preview only. Not for sale. Many pages are intentionally removed.