PXR3 Instruction Manual - Coulton Instrumentation

5 Setting methods of temperature andparametersOperation/Standby modeSV indication lamp is lit when the set value is shown.Control output statusAlarm statusSVC1C2AL1AL2· Some parametersmay not be displayedon the screen,depending upon thetypes.SELPress for about1 sec.SELSELPress for about 2 sec.(Returns to SV indication)1st block parameterParameterdisplay symbolSTbYProGLACHParameterStandby settingsRamp/soak controlAlarm latch cancelDescription of contentsSwitches RUN or Standby of the control.ON: Control standby (output: OFF, alarm: OFF)OFF: Control RUNOFF: stop, rUn: Start, HLd: status holdReleases alarm latch.1: Alarm latch releaseDefaultsettingOFFOFF0RemarksATAuto-tuning0: Stop, 1: Standard AT start, 2: Low PV type AT start0TM-1TM-2AL1Timer 1 displayTimer 2 displayAlarm 1 set valueTime display indicating the remaining time in the timermode.(appears only with alarm action type 1 to 10).Setting range: Note 1101010 Table 3(Note 1)A1-LA1-HAlarm 1 low limitset valueAlarm 1 high limitset value(appears only with alarm action type 16 to 31).Setting range: Note 11010Table 3(Note 1)Table 3(Note 1)AL2Alarm 2 set value(appears only with alarm action type 1 to 10).Setting range: Note 110Table 3(Note 1)A2-LA2-HAlarm 2 low limitset valueAlarm 2 high limitset value(appears only with alarm action type 16 to 31).Setting range: Note 11010Table 3(Note 1)Table 3(Note 1)LoCKey lockSetting of key lock status.All parametersSVFront key Comm- Front key Communicationunication0012345: Setting enable, : Setting disableNote 1) Setting range : 0 to 100%FS (in case of absolute value alarm)–100 to 100%FS (in case of deviation alarm)Note 2) Never set "TC" / "TC2" = 0– 14 –