PXR3 Instruction Manual - Coulton Instrumentation

Setting alarm 1 and 2Upper limit of alarm 1and 2Lower limit of alarm 1and 2(Setting range:Absolute value alarm: 0 to 100%FSDeviation value alarm: -100 to 100%FS )}(Option)[Description]• These parameters are used to for settings of alarm 1and 2.• When the alarm type ( or ) is set to 0 to 15,alarms 1 and 2 ( and ) can be set.• When the alarm type ( or ) is set to any valueother than 0 to 15, the upper and lower limits of alarm 1and 2 ( , , , ) can be set.[Note]Setting codes (12 to 15) cannot be selected in alarmtype 1 ( ).Related parameters: , (page 42), (page 53), (page 51), (page 54)[Setting example] Setting the operation value of alarm 2 to -10°CDisplayPV indicationSV indicationPV indication1.2.3.4.5.6.Press and hold the SEL key for one second.will be displayed.Press the key to display .Press the SEL key once.The current setting ( ) will be displayed.Operating procedurePress the or keys to flicker and to display .Press the SEL key once. will be displayed and the operation value -10°C will be registeredfor . After that, the controller will operate with the operation value of = -10°C.(Repeat the procedure from 3 to 5 to check the set value.)If you want to display the operation status, press and hold the SEL key for two seconds.The SV will be displayed on the display area.If unoperated state continues, the PV will be displayed.18