PXR3 Instruction Manual - Coulton Instrumentation

2-2 Basic operationsJust after power-on:The PV (process value) is displayed just after power-on.SVC1C2AL1AL2SELExp.) In case when the PV (process value)is 149.9.How to switch parameters:The figure below shows the basic operations for the PXR3.Basic operations for the PXR3(SV indication)SVC1C2AL1AL2SELSELDisplay state just after power-on(PV indication)SVC1C2AL1AL2SELParameter settingFlickers when the set value ischanged by pressing theor key.Stop flickering when the SVis registered by pressing theSEL key.Indication switching PV (process value)to / from SV (set value)SEL(apporox.1 second)OFFSV lampSEL(apporox.3 second)SEL(apporox.5 second)Set data indicationSELSELSet data registrationLit, flickersPress the SEL key toswitch PV to / from SV.Parameters ofthe first blockParameters ofthe second blockParameters ofthe third blockPressing and holding thekeys makes the value increaseor decrease fast.If it has not been operated for 30 seconds, the display returns to the PV display.Pressing the SEL key for 2 second after setting parameters, the indicationshifts to the SV indication state.How to set values:key: One press increases the value by 1.Press and hold this key to increase the value.key: One press decreases the value by 1.Press and hold this key to decrease the value.How to register the set data:By pressing the SEL key, the displayed values are registered.Note that the SV (SV0) will be registered in 3 seconds without any operation. (Refer to P.12)When changed the parameters “P-n2”, “ALM1” or “ALM2”, turn the power OFF and ON.11