PXR3 Instruction Manual - Coulton Instrumentation

Operation/Standby modeSV indication lamp is lit when the set value is shown.Control output statusAlarm statusSVC1C2AL1AL2· Some parametersmay not be displayedon the screen,depending upon thetypes.SELPress for about5 sec.SELSELPress for about 2 sec.(Returns to SV indication)3rd block parameterParameterdisplay symbolP-n1SV-LParameterControl actionLower limit of SVSelects the control action.Description of contentsLower limit of SV(Setting range: 0 to 100%FS)Defaultsetting0%FSRemarks0 Table 4(Page 4)SV-HUpper limit of SVUpper limit of SV(Setting range: 0 to 100%FS)100%FSdLY1dLY2ON delay time ofalarm 1ON delay time ofalarm 2ON delay time setting for alarm output(Setting range: 0 to 9999 sec)00A1hYA2hYHysteresis foralarm 1Hysteresis foralarm 2Sets ON-OFF hysteresis for alarm output.(Setting range: 0 to 50%FS)11A1oPAdditional functionof alarm 1Additional function of alarm output(Setting range: 000 to 111)000Note 3A2oPAdditional functionof alarm 2Alarm latch (1:use, 0:not use)Alarm of error status (1:use 0:not use)De-energized (1:use 0:not use), Note 3.dl-1dl-2DI1 operation settingDI2 operation settingSelects digital input 1 (DI1) function(Setting range: 0 to 12)Selects digital input 2 (DI2) function0(OFF)0(OFF)(Setting range: 0 to 12)STno Station No. Communication station No. (Setting range: 0 to 255) 1CoM Parity setting Parity setting. Baud rate is fixed at 9600 bps.(Setting range: 0 to 2)0PYP Code for PYP inputtypeInput type code used when communicating with PYP.See the OPERATION MANUAL(Initial value: K: 0 to 400 C)34Ao-T Retransmissionoutput typeSelecting retransmission output type.0: PV/ 1: Set point/ 2: Output/ 3: Error0: PVAo-L Retransmissionbase scaleSetting retransmission base scale.(Setting range : –100 to 100%)0%Ao-H Retransmissionspan scaleSetting retransmission span scale.(Setting range : –100 to 100%)100%dSP1todSP13Parameter mask Specifying parameter mask000Note 36-7(Page 3)6-7(Page 3)6-6(Page 3)Note 3) De-energized: Contact opens when the alarm "ON".– 16 –