PXR3 Instruction Manual - Coulton Instrumentation

Setting lower limit of the measuring range (Setting range: -1999 to 9999)Setting upper limit of the measuring range (Setting range: -1999 to 9999)Selection ˚C / ˚F (Setting: ˚C or ˚F )[Description]• These parameters are used for setting the lower and upperlimits of the measured range.• A decimal point position can be set in the parameter of.• For the current and voltage inputs, = , , and forother inputs, = are valid.• See the right table for input range.w Input range table (Standard range)Input typeResistancebulb JIS(IEC)ThermocoupleDirect-currentvoltagePt100ΩJJKKKRBSTTEENPL-II1 to 5 V DC0000-50-100-150-15000000000-150-1500-15000Range(°C)totototototototototototototototototototototo150300500600100200600850400800400800120016001800160020040080080013001300With / withouta decimal point(°C)*OOOOOOOXOOOOXXXXOOOOXX32323232-58-148-238-2383232323232323232-238-23832-2383232-1999 to 9999(Scaling is possible)Range(°F)totototototototototototototototototototototo3025729321112212392111215627521472752147221922912327229123927521472147223722372With / withouta decimal point(°F)*OOOXOOXXOXOXXXXXXXXXXXSettable upto 2 digits* O: withX: without* For 4 to 20 mA DC input, connect a resistance of 250Ω betweenterminals and to change the input to the 1 to 5 V DC input.[Note]The input accuracy is ±0.5%FS±1 digit except the cases shownbelow.Thermocouple R at 0 to 400 °C : ±1%FS ± 1 digit ±1˚CThermocouple B at 0 to 500 °C : ±5%FS ± 1 digit ±1˚COther kinds of thermocouples : ±0.5% FS ± 1 digit ±1˚C36