NetEx EFT213 Reference Manual Rel 5.4

Tailoring the Standalone Server execution JCLThe instructions below are provided as examples of how to set up z/OS JCL for NetEx/eFT. Your installationstandards and procedures may substantially change these examples in which case you may need to contactyour site administrator to provide further assistance.Two JCL examples are provided; one for running the Standalone Server as an z/OS batch program, and onefor running the Standalone Server under the control of TSO/E. Either one or both may be used depending onyour installation’s requirements.If you are going to run the Standalone Server as an z/OS program without running under the control of TSO/E(no remote command execution), tailor the example JCL in Figure 5 on page 112 according to the followinginstructions.Change the following to meet your installation requirements.• The JOB card(s)• The data set name “DSN=EFT.N24.LOAD” on the STEPLIB card.Change this name to the data set at your installation that contains the Standalone Server program module.This STEPLIB card can be deleted if your installation made the Standalone Server available via yourz/OS link list concatenation.• The service name “-SERVICE EFTSA”.It is recommended that the service name you choose for a Standalone Server not match the service namechosen for the Multiplex Server or other Standalone Servers. If any service names are the same, a remoteuser may be connected to any server offering the same name, causing confusing results.• You may also specify any other valid Standalone Server qualifiers needed at your installation in thePARM= text. The example JCL shows a 10 minute time limit “-TIMEOUT 600” being set.Submit the job for execution to run the Standalone Server.//EFTSJCL JOB ,'EFT SA SERV',CLASS=A,MSGCLASS=X//SERVER EXEC PGM=NUASSERV,REGION=2048K,// PARM='-SERVICE EFTSA -TIMEOUT 600'//STEPLIB DD DSN=EFT.N24.LOAD,DISP=SHR//SYSPRINT DD SYSOUT=*Figure 5. Standalone Server example JCLIf you are going to run the Standalone Server as a batch job under the control of TSO/E (allowing remotecommand execution without returned output), tailor the example JCL in Figure 6 on page 113 according tothe following instructions.Change the following to meet your installation requirements.• The JOB card(s)• The data set name “DSN=EFT.N24.LOAD” on the STEPLIB card.Change this name to the data set at your installation that contains the Standalone Server program module.This STEPLIB card can be deleted if your installation made the Standalone Server available via yourz/OS link list concatenation.• The TSO/E “PROFILE PREFIX(EFT)” command. This can be used to set the initial TSO/E prefix andNetEx/eFT “DIRectory” qualifier for user start up file processing. The user start up file that would bePage 112 Advanced Local User’s Guide REF-eFT213-R5.4-08