NetEx EFT213 Reference Manual Rel 5.4

UA-4501 Nested (or recursive) input/alias limit of NNN exceededSeverity: ErrorExplanation: NetEx/eFT restricts the number of times an input script or alias can call itself or anotherscript/alias; the current limit is ten levels. This error can also be a result of a user failing to escapealias processing (using the ‘!’ escape character) when redefining a NetEx/eFT command as an aliaswithin a multicommand alias.UA-4504 Bad output FORMAT definition - reset to defaultSeverity: ErrorExplanation: A user can redefine the format of error messages by using the SET OUTPUTFORMAT command. This message results when the new definition does not begin with ‘{}’ to disablestring substitution.UA-4505 Input request (NNN byte maximum) failedSeverity: ErrorExplanation: NetEx/eFT provides a buffer for holding a multiline command or alias; this error occurswhen that buffer is exceeded. If a large command or alias is required, it should be defined as anInput Script.UA-4601 Variable ‘SSS’ contains invalid charactersSeverity: WarningExplanation: A variable name was created that contains invalid characters; SSS represents the variablename. Valid characters are alphanumeric ‘A’.. ‘Z’, ‘0’.. ‘9’. It is recommended for future compatibilitythat variable names and alias names begin with an alpha character ‘A’.. ‘Z’.UA-4701 Recursive alias ‘SSS’Severity: WarningExplanation: A warning message resulted when NetEx/eFT attempted to execute a single line aliasthat was recursive (it calls itself). A common cause of this error is executing an alias that calls an aliasthat calls the first alias back again.UA-4704 Use SET LOCAL/REMOTE to modify SSS qualifier ‘SSS’Severity: WarningExplanation: Some LOCAL and REMOTE qualifiers cannot be modified with some NetEx/eFTcommands. This error occurs if a user attempts to modify either current directory by means of a -DIRswitch on a SEND, RECEIVE, LOCAL, or REMOTE command line.UA-4709 Command token is greater than NNN charactersSeverity: WarningExplanation: A token is a sequence of characters separated by either blanks, tabs, end-of-line, or anycombination thereof. The token cannot exceed NNN length. Note that a token, enclosed in quotes,can include spaces.UA-4804 MAXRECORD (NNN+NNN) too large for BLOCKSIZE (NNN)Severity: ErrorExplanation: MAXRECORD plus the record header size must be less than or equal to theBLOCKSIZE negotiated at connect time. To correct the error, reduce the MAXRECORD qualifier,reconnect with a larger BLOCKSIZE, or enable the PARTialrecord qualifier.UA-4809 Sequence error (NNN vs. NNN) in record RECEIVESeverity: ErrorExplanation: NetEx/eFT has a sequence number associated with each record in a RECORD MODEfile transfer. A sequence error is probably caused by a network interruption.Page 228 Appendix B. NetEx/eFT Error Messages for IBM z/OS REF-eFT213-R5.4-08