NetEx EFT213 Reference Manual Rel 5.4

Table 3. List of FunctionsFunction Description PageGE Tests if the first number specified is greater than or equal to the second. 81GT Tests if the first number specified is greater than or equal to the second. 81INC Tests if the first number specified is greater than the second. 69INDEXReturns the position of the second string specified within the first string. Thefunction returns zero if the second string is not found.LE Tests if the first number specified is less than or equal to the second. 81LEN Returns the count of characters that make up the specified string. 80LOWERReturns the lower case equivalent of a string expression, all characters but uppercase are left untouched.LT Tests if the first number specified is less than the second. 81MODReturns the remainder of the division of the first numeric string expressionspecified by the second.MUL Multiplies two numeric string expressions and returns the result. 69MSGReturns the information of the last message. MSG is most often used to tailorthe NetEx/eFT output message formatNDF Tests if a variable is not defined. 74NE Tests if the first number specified is not equal to the second. 81NES Tests if the first string specified is not equal to the second. 77PARAMSSLEEPSTATUSSUBSubstitutes the positional parameters specified. It is important to note thatquoted parameters remain quoted and are considered one whole parameter –regardless of imbedded spaces.Causes NetEx/eFT to pause or “sleep” for a specified number of seconds. Thisprocess is not interruptible. This function results in a null stringReturns the single status character of the previous command:S = Success, E = Error.Subtracts the second numeric string expression specified from the first andreturns the result.TIME Returns the system time of the local host. 87UPPERReturns the upper case equivalent of a string expression, all characters butlower case are left untouched.798269838485866982Page 68 Advanced Local User’s Guide REF-eFT213-R5.4-08