NetEx EFT213 Reference Manual Rel 5.4

UA-5120 The MESSAGE stack is emptySeverity: ErrorExplanation: Refer to previous identical message: UA-4127UA-5206 Use SET LOCAL/REMOTE to modify SSS qualifier ‘SSS’Severity: WarningExplanation: Refer to previous identical message: UA-4704UA-5304 Invalid ARCHIVE file format [SSS]Severity: ErrorExplanation: This error results from trying to use the RESTORE MODE to SEND or RECEIVE afile that was not created by a BACKUP MODE transfer, or to use COPY MODE to SEND orRECEIVE a file to or from a host that is a different type from the local host (i.e. not peer-to-peer).UA-5305 Invalid ARCHIVE block length (NNN)Severity: ErrorExplanation: This error results from trying a RESTORE or COPY MODE file transfer on an incompatibleHOSTTYPE or ARCHIVE file.UA-5306 Incomplete ARCHIVE file - missing end-of-fileSeverity: ErrorExplanation: This error results from trying a RESTORE mode file transfer on a container file that(for some reason) is not complete. The most likely reason is that the BACKUP mode transfer thatcreated the file was aborted, leaving a partial file with missing data and no Archive end-of-file mark.UA-5401 SSS more than NNN levels of nested stringsSeverity: WarningExplanation: This warning occurs with string substitution. If the nesting level is more than NNN,this warning results. (i.e., if NNN is 8, then {{{{{{{{{password}}}}}}}}} causes a warning.)UA-5406 Empty string substitutionSeverity: WarningExplanation: This warning results when NetEx/eFT is unable to find an alphanumeric string (stringvariable or function) where one was expected. This is generally due to a syntax problem caused by amissing parameter to a string function or a missing function name itself. Make sure that a string substitutiondoes not result in a null string. For example, placing too many, or unnecessary brackets ‘{’‘}’ around a variable or argument will cause this warning condition.UA-5603 Character code cannot be translatedSeverity: WarningExplanation: This warning results from the TRANSLATE command to define character translations.Characters that cannot be redefined are Uppercase alpha (“A”.. “Z”), digits (“0”.. “9”), space(“”), equal (“=”), and null (“”).EFT213-2002 Data checksum (CRC) error at block NNNSeverity: ErrorExplanation: File transfer with -CRC ON detected a checksum error in block number SSS. The 32-bit checksum is computed by the source host and verified by the destination host. The verificationfailed due to some network interruption. The file transfer is aborted and the destination file may notbe complete. Correct the problem and retry the command.REF-eFT213-R5.4-08 Appendix B. NetEx/eFT Error Messages for IBM z/OS Page 229