AWS 924-948 - Solid State Logic

DAW Control20Setting Pre and Post RollHold down ALT and press the PRE or POST button to highlight the left hand numeric field of the pre-roll or post-rolltime window. The time is displayed on the console TFT screen in place of the DAW position. The selected numeric fieldwill flash. Use the navigation left/right arrow keys to select a different numeric field if required, then enter a value on thenumeric keypad or use the Up/Down arrow keys to increase or decrease the selected field.Press ENTER to confirm the time.The CLR button on the numeric keypad can be used to clear the selected time.20 Setting start (In) and end (Out) TimesHold down ALT and press the IN or OUT button to highlight the left hand numeric field of the start or end time window.The time is displayed on the AWS TFT screen in place of the DAW position. The selected numeric field will flash. Use thenavigation left/right arrow keys to select a different numeric field if required, then enter a value on the numeric keypad oruse the Up/Down arrow keys to increase or decrease the selected field.Press ENTER to confirm the time.The CLR button on the numeric keypad can be used to clear the selected time.20 AuditionThis function allows the IN, OUT, PRE and POST points to be checked.Select the AUD button then press either the PRE, IN, OUT, or POST button. Press the AUD button again to cancelthe function.When Audition mode is selected the transport section of the TFT screen displays audition in place of the Pre and Postindicators.PREPlays from the pre-roll point to the selection start pointINPlays from the selection start point for the post-roll timeOUTPlays from the end point less the pre-roll time to the end pointPOSTPlays from the selection end point for the post-roll timeALT+OPTION+PRE or IN Plays from the selection start point less the pre-roll time to the selectionstart time plus the post-roll timeALT+OPTION+POST or OUT Plays from the selection end point to the selection end point plus post-rolltime.AWS Footswitch ControlThe AWS has two 6.35mm jack footswitch connectors on the rear of the console (see Section 3). These are intended forhands-free access to essential transport functions:Footswitch Control One:Footswitch Control Two:Either plays or stops the DAW. Holding down SHIFT will abort a recordingif in record, or initiate half-speed playback if stopped.Used to activate or deactivate Record mode. Holding CTRL while pressingthe foot switch will cycle through record modes.Page 4-18AWS 924-948 Owner’s Manual