AWS 924-948 - Solid State Logic

Analogue OperationsTrack Bus Master ControlsThe master output level controls for the eight track busses are located in the top right of the centre section.The Track bus levels are displayed in the eight meters in the lower left-hand quarter of the LCD meteringabove the bus master controls.The gain ranges from -∞ to +10dB and the pots are indented at the ‘12 o’clock’ position, which correspondsto 0dB gain.Following level control, the bus outputs can be injected with tone (using the Oscillator’s TRACK switch– see Page 3-26) and talkback (using the talkback SLATE switch to the right of the shuttle wheel – see Page3-25) before being fed to the connector panel.An AFL function (post tone and talkback inject) is provided for each bus. Selecting AFL on a single trackbus will route signal to both left and right AFL busses, whereas selecting it on odd and even numberedbusses will route the odd numbered output to the left AFL bus and the even numbered output to the rightAFL bus.Cue/FX Send Master ControlsEach channel is fitted with one Cue Stereo and two mono FX controls for use as foldback or feeds to effectsdevices etc. The Cue Stereo controls in each channel may be routed to one of two busses – Cue Stereo Aor Cue Stereo B. Similarly the FX1 controls can be routed to either the FX 1 or FX 3 bus, and the FX2controls to the FX 2 or FX 4 bus.The output level controls for the Cue and Aux busses are located in the top right of the centre section (seeright). The bus levels are displayed in the eight meters in the lower right-hand quarter of the LCD meteringabove the bus master controls, with the cue bus components labelled AL, AR, BL and BR, and the FXbusses labelled 1 to 4.The gain ranges from -∞ to +10dB and the pots are indented at the ‘12 o’clock’ position, which correspondsto 0dB gain.An AFL function is provided for each output. Selecting AFL on a single track bus will route signal to bothleft and right AFL busses, whereas selecting it on odd and even numbered busses will route the oddnumbered output to the left AFL bus and the even numbered output to the right AFL bus.Cue and FX bus injectionIn order allow external signals (such as a stereo sum of additional DAW channels) to be added to the Cueand FX sends signal without using up desk channels, bus inject connections are provided on the consoleconnector panel for each Cue and FX bus. Signals brought in on these connectors are simply added to theCue and FX busses at unity-gain, before the AFL function and output level control.AWS 924-948 Owner’s Manual Page 3-23