AWS 924-948 - Solid State Logic

AWS 948 Tutorialbus routingTo route channels to the Record and Mix busses, press the reC and/or MIX switch to the right of thechannel pan pot. For in-line signals, the reC and MIX switches operate on the channel path assigned tothe main fader. Press on the V-pot below the reC and MIX switches to switch the main fader and V-pot. The reC and MIX switches now control the routing of the secondary path.Use the eight numbered switches immediately underneath the channel meters (shown above right) toroute to the track busses. By default, signals are sent post-fader. To source the send pre-fader or post pancontrol,press the Pre or PAn switches beneath the track bus selection switches. Centre section trackbus controls are located in the top right-hand corner of the console.Panning, Width and balanceThe pan pot towards the bottom of the channel strip is used to adjust the stereo position of signals beingsent to the Record and Mix busses, as well as to the Track busses when they are functioning in stereo.For stereo signals, the pan pot functions as a width controller. Stereo signal balance is controlled using theV-pot just above the channel’s digital display.In In-line Mix mode, the main channel pan pot operates on the primary channel path; in ln-line Track modeit operates on the monitor path. By default, the Cue ST pan pot controls pan for the other channel pathwhenever it is routed to a stereo bus (as indicated by the Cue LED to the left of the Cue ST pan potbeing unlit) and the Cue pan follows the main channel pan. Deselect Cue F-Ch (Cue Follows CHannelpan) in the Channel Setup screen (See Page 2b-8) to switch the Cue ST pan pot from the channel pathto the Cue send.Channel level, Cut and SoloThe channel fader controls the channel send to the Rec and Mix busses, as well as any other sends whichare operating post-fader.For In-line Track mode, the main fader controls the secondary channel path (monitor path), and the V-potcontrols the primary channel path. In In-line Mix mode the channel fader controls the primary path andthe V-pot the secondary path. Pressing the V-Pot will swap the paths assigned to fader and V-Pot.Use the CuT and SOlO switches below the digital display to mute or solo the signal assigned to thefader.Note the SEL switch is used for assigning the channel to certain centre section configuration procedures,including the channel mode set-up in the TFT screen.Page 2b-10AWS 924-948 Owner’s Manual