AWS 924-948 - Solid State Logic

AutomationSnap ModeSnap mode uses the fader touch sensor to control both the start and end of a fader update for fast hands on changes tomix levels. When the fader is released it ramps back to the previous mix level at a user determined rate, then returns toreplay.Start positionwhen fader isfirst touchedWhen fader isreleased it ramps backto previous mix levelGlide time can be setin the Setup menu ifdesiredThis feature is only available with Motors ONAutoTakeoverTo avoid a level jump when dropping out of write, AutoTakeover introduces nulling indicators in the scribble strip to displaythe direction to move the fader to match the underlying mix level. When the fader crosses the current mix level, it isautomatically returned to replay and disconnected from the audio gain element. The fader returns to following the mix dataas soon as it is physically released.Start positionwhen fader isfirst touchedEnd position whenfader is releasedManual glide willswitch off automationonce past originalautomation levelScribble strip indicatesdirection to move thefader back to itsoriginal positionCopy and SwapCS (Copy and Swap) are used to interchange or transfer mix data between channels. The required function is selected bypressing the CS key to toggle through modes. Copy is displayed as a highlighted Cpy, Swap as an Swp. Select the functionrequired then hold down the source channel auto switch then press the destination channel using its auto switch. Whilstthe auto switches are active, ‘src’ and ‘dest’ will be displayed in the scribble strips above the fader. To Copy or Swapautomation data the system must be in Mix Running or Mix Review.Copy is to a single channel only. To copy to multiple channels, repeat the Copy operation as many times as required.The new Mix data is not saved until the subsequent Mix Pass is Ended.Deleting Mix Passes from the ConsoleMix Passes can be deleted from memory by highlighting the Mix Pass you wish to delete in the TFT screen, holding downthe Delete soft key and pressing the Confirm soft key. Mixes can also be deleted from the AWS Remote.Page 7-14AWS 924-948 Operator’s Manual