AWS 924-948 - Solid State Logic

Analogue OperationsScribble StripsChannel DisplayThe channel display functions as a digital scribble strip. It displays the analogue channel name when in Analogue Focus mode,as defined in the Remote Browser. In DAW Focus mode, it displays the name of a DAW track, selected send, or I/O dataaccording to the function currently assigned on the Master Control Panel.AWS 948When in an In-line mode, the upper row of the digital scribble strip displays any name associated withthe channel path assigned to the V-pot, and the lower row displays any name associated with the channelpath assigned to the channel fader.See Section 4 for more information on DAW control, and Section 5 for more information on editing channelnames in the Remote Browser.Chinagraph Scribble StripThe channel strip provides a traditional scribble strip – use it for scribbling on.Channel SelectionThe SEL button is used for assigning the channel to the centre section for certain set-up procedures.A contiguous range of channels can be selected by pressing and holding the SEL button for the lowestchannel in the range, then pressing the SEL button for the highest channel. To select all channels, use theALL softkey which appears in the lower row of the Function keys when no upper Function key is selected.When the SET Function key (next to the ALL Function key) is selected, pressing any in-channel nonlatchingswitches (such as the FX activation switches and RETURN switch) will cause that switch toactivate in all selected channels.SEL buttons are also used for selecting channels in the DAW or for record-readying DAW tracks. SeeSection 4 for more details.Cut and Solo SwitchesThe CUT and SOLO switches below the digital display allow the signal assigned to the fader to be mutedor soloed. Similarly, the CUT and SOLO switches above the digital display allow the signal assigned tothe V-pot to be muted or soloed.CUT switches work on all post-fader sends by default. However, it is possible to configure them to mutepre-fader sends as well. This is done using the Input Cut Enable option in the TFT screen’s ConsoleSetup menu, described on Page 3-28.924 and 948AWS 948The solo-in-place function of the two channel paths can be linked together using the LNSL Function key, described on Page3-15.The solo function can be configured via the AFL/PFL Function keys, as described on Page 3-20.Solo IsolatesTo prevent any channels from being muted when a SOLO switch is pressed, select the AFL/PFL Function key followedby the ISO softkey which appears beneath it, then press any SOLO switches which you wish to isolate from the Solofunction. Selected switches will flash (along with the ISO softkey). When all the required channels have been solo isolated,deselect the ISO softkey. See Page 3-20 for more details regarding AFL/PFL Function key operations.Page 3-12AWS 924-948 Owner’s Manual