AWS 924-948 - Solid State Logic

More documents

Recommendations

Info

G: TroubleshootingTroubleshooting Chart – Channel baysProblem Problem Check Check Solution SolutionChannel Meter Panels do notfunction correctly.Are the ribbon connectors in the rear ofthe Meter Panels seated correctly?If no, re-seat as required.Swap Meter Panels 1 and 3. Do the metersin Bays 2 and 3 now work? Note: ChannelMeter information from the CPU isbuffered through Bay 3’s Meter to Bay 2and then on to Bay 1.If yes, replace the MeterPanel in Bay 1.Remove the Meter Panel in Bay 3.Remove the screening can fitted around theprocessor. Check the ribbon connection insocket PL6.if no, re-seat as required.Solo and Cuts Panel in onebay does not function.Is the ribbon connector on the rear of thepanel seated correctly?Check fuse FS1_4V on the 626630X1 FaderBuscard.Swap the problem panel with a workingpanel from another bay. Does the problemstay in the same bay?If no, re-seat as required.Replace as required –replacement fuses aresupplied with the console.If not, replace the Solo andCuts Panel.Are the ribbon connections to the faderbus card in the bay displaying the faultseated correctly?Swap the fader bus card in the faulty baywith a known working bus card from analternate bay. Does the problem stay in thesame bay?Re-seat as required.If no, replace the fader buscard.Raising the Channel Fadergives no increase in channelgain.Swap the fader with one from an adjacentchannel. Does the problem follow thefader?If yes, replace the fader.Swap the channel strip with an adjacentchannel. Does the problem follow thechannel strip?If yes, replace the channelstrip.All channel strips in one baydo not function.Refering to Control Overview diagram,ensure that the Multidrop Bus connectorbetween the Channel Backplane and theCPU is seated correctly.Re-seat as required.Appendices Page A-20AWS 924-948 Owner’s Manual
G: TroubleshootingTroubleshooting Chart – Centre sectioProblem Check SolutionMotion Control Panel doesnot function.Workstation Panel does notfunction.Monitor Panel does notfunction.GPIO port does notfunction.Video Display does notfunction.Centre Section meter doesnot function.Is the connector labelled IN on the MotionControl Panel seated correctly?Is the connector labelled WSINOUT on theMotion Control Panel seated correctly?Is the connector labelled MONINOUT on theMonitor Control Panel seated correctly?Is the connector labelled MONINOUT on theMotion Control Panel seated correctly?Is the connector labelled MONINOUT on theMonitor Panel seated correctly?Is the connector labelled PL2 on the MotionControl Panel seated correctly?Is the connector labelled MONINOUT on theMotion Control Panel seated correctly?Is the connector labelled MONINOUT on theMonitor Panel seated correctly?Remove Workstation Panel. Remove displaypanel. Is the 30–pin ribbon connector seatedcorrectly?Is the connector labelled DVIDEO2 on theCPU card seated correctly?Is the connector labelled IN on the MeterPanel seated correctly?Is the connector labelled PL11 on the CPUseated correctly?If no, re-seat as required.If no, re-seat as required.If no, re-seat as required.If no, re-seat as required.If no, re-seat as required.If no, re-seat as required.If no, re-seat as required.If no, re-seat as required.If no, re-seat as required.If no, re-seat as required.If no, re-seat as required.If no, re-seat as required.AWS 924-948 Operator’s Manual Appendices Page A-21
Page 1 and 2:
AWS 924-948OWNER’S MANUAL
Page 3 and 4:
IntroductionIMPORTANT INFORMATIONTh
Page 5 and 6:
IntroductionCaution!When installing
Page 7 and 8:
IntroductionMANUAL INDEXØ switch 3
Page 9 and 10:
IntroductionPPAD switch 3-6PAN swit
Page 11 and 12:
IntroductionMANUAL CONTENTSImportan
Page 14 and 15:
IntroductionSECTION 3: ANALOGUE OPE
Page 16 and 17:
IntroductionThe Default Button 4-10
Page 18 and 19:
IntroductionThe Projects Tab 5-5Cop
Page 20 and 21:
IntroductionAPPENDICESSection Conte
Page 22 and 23:
IntroductionKey Features• Combina
Page 24:
AWS InstallationThis page is intent
Page 27 and 28:
Pre InstallationINSTALLATIONPRE-INS
Page 29 and 30:
Pre InstallationUnpacking the Conso
Page 31 and 32:
Studio IntegrationSTUDIO INTEGRATIO
Page 33 and 34:
DAW ConnectionDAW CONNECTIONThe AWS
Page 35 and 36:
DAW Connection• Using an RJ45 cab
Page 37 and 38:
DAW ConnectionDirect Network Connec
Page 39 and 40:
DAW ConnectionSetting Your Workstat
Page 41 and 42:
DAW ConnectionLogic Pro 9When Logic
Page 43 and 44:
DAW ConnectionNetwork Troubleshooti
Page 45 and 46:
DAW ConnectionAssigning the AWS IP
Page 47 and 48:
AWS 924-948OWner’S MAnuAlSeCTIOn
Page 49 and 50:
AWS 924 Tutorial2b - AWS 948 TuTOrI
Page 51 and 52:
AWS 924 TutorialAWS 924 TuTOrIAlStu
Page 53 and 54:
AWS 924 Tutorial924 ChAnnel STrIPIn
Page 55 and 56:
AWS 924 TutorialCenTre SeCTIOnAdjus
Page 57 and 58:
AWS 948 TutorialAWS 948 TuTOrIAlFOC
Page 59 and 60:
AWS 948 TutorialChAnnel MOdeSWhen i
Page 61 and 62:
AWS 948 TutorialAnalogue-style In-l
Page 63:
AWS 948 TutorialAdditional return M
Page 66 and 67:
AWS 948 Tutorialbus routingTo route
Page 68 and 69:
AWS 948 TutorialThis page is intent
Page 70 and 71:
Analogue OperationsThis page is int
Page 72 and 73:
Analogue OperationsMix and Rec Bus
Page 74:
Analogue OperationsThe TFT ScreenTh
Page 78 and 79:
Analogue OperationsInput configurat
Page 80 and 81:
Analogue OperationsInsert PointTo s
Page 82 and 83:
Analogue OperationsDirect OutputBy
Page 84 and 85:
Analogue OperationsScribble StripsC
Page 86 and 87:
Analogue OperationsBus MeterPanelOs
Page 88 and 89:
Analogue OperationsMonitoring1Turn
Page 90 and 91:
Analogue OperationsMonitor InsertTh
Page 92 and 93:
Analogue OperationsMonitor Level Di
Page 94 and 95:
Analogue OperationsDynamics Operati
Page 96 and 97:
Analogue OperationsFoldback Headpho
Page 98 and 99:
Analogue OperationsCommunications S
Page 100 and 101:
Analogue OperationsConsole Setup Me
Page 102 and 103:
Analogue OperationsDAW setupDAW set
Page 104 and 105:
DAW ControlThis page is intentional
Page 106 and 107:
DAW ControlMotion Control Panel 4-1
Page 108 and 109:
Page 110 and 111:
DAW ControlFocus ModesIn order to a
Page 112 and 113:
DAW ControlCommunication with your
Page 114 and 115:
DAW ControlSetup GuidelinesWhen mov
Page 116 and 117:
DAW ControlThe Master Control Panel
Page 118 and 119:
DAW ControlSHIFT allows selection o
Page 120 and 121:
DAW ControlChannel Solo and Cut Til
Page 122 and 123:
DAW Control5Select ModeAll 24 chann
Page 124 and 125:
DAW ControlInput, Output and Send R
Page 126 and 127:
DAW Control20Setting Pre and Post R
Page 128 and 129:
DAW Control24Shuttle/Scrub WheelThe
Page 130 and 131:
DAW ControlPlug-In Display ModesThe
Page 132 and 133:
Page 134 and 135:
DAW Control3. Edit Tools MenuEdit T
Page 136 and 137:
Page 138 and 139:
DAW ControlSuspending AutomationTo
Page 140 and 141:
DAW ControlThe majority of DAW func
Page 142 and 143:
DAW ControlThe Logic TemplateThe AW
Page 144 and 145:
DAW ControlNuendo/Cubase TemplateAs
Page 146 and 147:
DAW ControlNuendo Control screenFky
Page 148 and 149:
DAW ControlSonar Console LayoutTRAC
Page 150 and 151:
DAW ControlDigital Performer Templa
Page 152 and 153:
Page 154 and 155:
Projects and the RemoteThis page is
Page 156 and 157:
Page 158 and 159:
Page 160 and 161:
Projects and the RemoteOnce a conne
Page 162 and 163:
Projects and the RemoteCopying Titl
Page 164 and 165:
Page 166 and 167:
Page 168 and 169:
Page 170 and 171:
Page 172 and 173:
Page 174 and 175:
Total RecallThis page is intentiona
Page 176 and 177:
Page 178 and 179:
Page 180 and 181:
Setup Guide: IO ConfigThis page is
Page 182 and 183:
Setup Guide: IO ConfigThe Channel D
Page 184 and 185:
Page 186 and 187: Total RecallThis page is intentiona
Page 188 and 189: Total RecallThis page is intentiona
Page 190 and 191: AutomationThis page is intentionall
Page 192 and 193: AutomationThis page is intentionall
Page 194 and 195: Setup Guide: Console ConfigWORKING
Page 196 and 197: AutomationOPERATIONActivating the A
Page 198 and 199: AutomationTo start a mix, press Exe
Page 200 and 201: AutomationJOIN AND REVISEAt any tim
Page 202 and 203: AutomationSELECTING PROTECTIONEach
Page 204 and 205: AutomationAUTOMATION OPTIONSTrimA m
Page 206 and 207: AutomationSnap ModeSnap mode uses t
Page 208 and 209: AutomationFADER LINKSFader Links ar
Page 210 and 211: AutomationTo set up MMC locates, op
Page 212 and 213: AutomationMIDI SYSEX LOADFor legacy
Page 214 and 215: AppendicesThis page is intentionall
Page 218 and 219: AppendicesConsole DimensionsSolid S
Page 222 and 223: C: Connector PinoutsConnector Pinou
Page 230 and 231: G: TroubleshootingAgain for the sak
Page 232 and 233: G: TroubleshootingThe Channel Strip
Page 234 and 235: G: TroubleshootingThe Channel Meter
Page 242 and 243: J: Block DiagramsJ: BLOCK DIAGRAMSF
show all

AWS 924-948 - Solid State Logic

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?