AWS 924-948 - Solid State Logic

DAW Control24Shuttle/Scrub WheelThe dual-concentric Shuttle/Scrub wheel has a spring-loaded outer ring and a continuously variable inner wheel forcontrolling DAW scrub and shuttle functions and for general timeline/clip navigation.Navigation ModeWhen the inner wheel is rotated, a stream of Nudge Commands are sent to the DAW according to rotation direction andspeed. The playhead will step through the session timeline according the current nudge value. If a clip or MIDI note isselected, its position can be nudged via the wheel.Shuttle ModeWhen the DAW is stopped, turning the outer rim activates shuttle mode. The outer rim will step through seven fixedshuttle speeds, while the inner controller provides continuously variable control of shuttle speed.Scrub ModeSelect a region to scrub within your DAW. Press the SCRUB button next to the wheel. The inner wheel now becomesan analogue tape machine style scrub wheel for the DAW.Using the Numeric Keypad to ShuttleIn Pro Tools, the numeric keypad can be used to control shuttle speed and direction. Engage Shuttle Mode via the outerrim. Hold down the CTRL button followed by a number on the numeric keypad that represents the shuttle speed. The+/- buttons control the direction of shuttle.Exit from Scrub/Shuttle ModeTo exit from shuttle mode press either the STOP or ESC button. To exit from Scrub mode, deselect the SCRUB Keyor press either the STOP or ESC button.Notes on Scrub and Shuttle Modes (PRO TOOLS HUI ONLY)The position at which the scrub/shuttle starts is derived from the current selection or timeline position. Scrub/Shuttle modecan commence from the selection end point by holding down the OPTION button before you grab the shuttle wheel.Holding down the ALT button will increase the resolution of the scrub/shuttle wheel.When scrub or shuttle is active, many DAW functions are suspended until you exit from scrub/shuttle mode.The following functions are available:• Fader control, solo and cut buttons• Scrub/Shuttle wheel functions• Transport controls• Enter button (to create marker/cue events)23Numeric KeypadThe console’s numeric keypad replicates the numeric keypad on your DAW keyboard. The primary use for this keypad isfor saving and recalling Memory Locates and entering data values (please refer to your DAW manual for more details onkeypad uses).Working with Markers/Memory LocationsTo Enter a Marker/Cue point – press ENTER.To Recall a Marker/Cue point – press a number followed by the decimal point button (Numeric Keypad in Classic mode)or a decimal point followed by a number followed by the decimal point button (Numeric Keypad in Transport mode).Page 4-20AWS 924-948 Owner’s Manual